HUMMINBIRD 760034-1 Charger Choke Instructions
- June 12, 2024
- Humminbird
Table of Contents
HUMMINBIRD 760034-1 Charger Choke
Determine Whether to Install the Choke Cable
Reduce Noise Interference Using a Choke Cable
If an on-board charger is present and attached to the cranking battery , install the choke cable (included) to reduce noise interference in the transducer.
If there is not an on-board charger connected to the cranking battery , the choke cable is not required.
Install the Choke Cable
Use the following instructions to install the choke cable.
Supplies: Wire cutter, wire stripper, wire crimper, safety glasses, protective gloves, and a heating agent.
WARNING! Disconnect the power source for all related equipment before you start the installation.
-
Disconnect the on-board charger from the main power source.
-
Disconnect the charger cable from the cranking battery.
-
Use a wire cutter to cut the charger cable between the fork in the output cable and the fuse holder. The fuse holder should always remain within 7″ of the battery terminals.
-
Strip back the shield on each end of the cut wires approximately 1/4 inch (6.4 mm).
-
Connect the stripped wires of the charger cable to the choke using the butt connectors on both sides of the cut wire (red to white and black to black).
-
Securely crimp the wires in the butt connectors.
-
Apply heat over the splice connection shrink insulation to secure the connection.
WARNING! Use extreme caution when applying heat to the shrink insulation. -
Connect the terminals on the charger cable to the cranking battery.
CUSTOMER SUPPORT
Contacting Humminbird®
Contact Humminbird Technical Support through our Help Center at
https://humminbird-help.johnsonoutdoors.com/hc/en-us.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>