Concox JM-VL03 GNSS Vehicle Terminal User Manual
- June 12, 2024
- Concox
Table of Contents
Concox JM-VL03 GNSS Vehicle Terminal
Product Overview
SMS Commands
Troubleshooting
-
Real-time tracking
-
Driving behaviour analysis (4 types)
-
Serial port (optional)
-
Over-speed alert
-
SOS alert
-
Tamper alert
-
Removal alert
-
Power-supply-cut alert
Low power alert -
Vibration alert
-
Geo-fence
Standard Parts List
Specification
Product Setup
- Prepare a micro SIM card that supports the same network as this device.
- Remove the upper cover of the device.
- Insert the SIM card into the slot and toggle the switch to ON.
- To ensure waterproofing takes effect, make sure the silicon rubber ring is installed in place.
- Press the upper case down and make sure all 5 clips are completely in place.
LED Indication
Power supply Status (Red, Blue, Green)
Interfaces
6 Pin RS485/TTL Version (Optional)
Wiring of Standard Version
Tips for finding the right wires:
- Use the multimeter to find out the positive and negative sides of the vehicle battery.
- Note: No matter whether the ignition key is switched to ON or OFF, the current battery voltage can be shown in the multimeter.
- The way to find the ACC wire: Connect the multimeter’s black probe to the negative side, and connect the red probe to a random wire, at this moment, the voltage shown in the multimeter is OV; turn the key to ON, if the supply voltage is shown, that’s the correct ACC wire.
- Connect the two connectors, if the vehicle has no connector, please connect the device’s wires to the corresponding vehicle wires.
Output power:
- GSM 900MHz: 29dBm(MAX), GSM 1800MHz: 26 dbM(MAX)
Declaration of Conformity
- Hereby, ShenZhen Jimi loT Co., Ltd declares that the radio equipment type JM-VL03 complies with Directive 2014/53/EU. and this product is allowed to be used in all EU member states.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>