HAOLIYUAN SBM04U Motion Sensor User Manual

June 3, 2024
HAOLIYUAN

HAOLIYUAN SBM04U Motion Sensor User Manual

Know about the sensor

Quick Installation Guide

Note: The Smart Life app should be installed and registered a account first (Smart Life can be searched in APP Store or Google Play).Then make sure the Gateway is added and on-line before the next.

Power on the sensor

Open the battery cove

Remove the insulation sheet

Option:lt also can be supplied by USB DCSV,at this time the battery will be saved.

Make device to enter pairing mode

Press and hold the button for 5 seconds until the LED blinks

Device pairing

Open “Smart Life” app,Enter gateway homepage and click “Search new device” or “Add Devices” and follow the in-a pp instructions to connect the device to your gateway.
**Gateway

**

Waiting for a few seconds, This device is added successfully and you may rename it. Click “Done” to finish the setting.

Added successfully

Motion & brightness Sensor L Device added successfully

Device Installation

Close the battery cover then put it where you need it .For good detection range, the installation height should be 1.s-2.1 meters. Please refer to the view below to find out the installation place you need.

**Top view

Sideview
**

Battery Change

The sensor works with a replaceable CR123A 3.0V battery. If you received the low battery alarm on app, please replace the battery and ensure the new battery is installed in the right direction.

Open the Lid

Replace the battery

Close the lid

FCC Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.a
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.
    The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals