HAOLIYUAN SBM02 Motion Sensor Installation Guide

June 5, 2024
HAOLIYUAN

HAOLIYUAN SBM02 Motion Sensor

HAOLIYUAN-SBM02-Motion-Sensor-
product

Quick Installation Guide

HAOLIYUAN-SBM02-Motion-Sensor-
fig-1

Note: The Smart Life app should be installed and registered as an account first(Smart Life can be
searched in APP Store or Google Play). Then make sure the Gateway is added and online before the next.

Power on the sensor

Remove the insulation sheet

Make the device enter pairing mode

Press and hold the button for 5 seconds until the LED blinks.

Device pairing

Open the “Smart Life” app, Enter gateway homepage and click 11Search new device11 or “Add Devices” and follow the in-app instructions to connect the device to your gateway.

Waiting for a few seconds, This device is added
successfully and you may rename it. Click “Done” to finish the setting.

Put it where you need it

The installation height should be 1.2-2.1 meters. The detect range is 120 degrees.

Battery Change

The sensor works with a replaceable CR2 3.0V battery. If you received the low battery alarm on an app, please replace the battery and ensure the new battery is installed in the right direction.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.
  • Caution: Any changes or modifications to this device not explicitly approved by

the manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals