Haoliyuan SBLM04 Motion and Brightness Sensor Installation Guide

June 5, 2024
HAOLIYUAN

Haoliyuan logo

Know about the sensor

Haoliyuan SBLM04 Motion and Brightness Sensor - fig1

Quick Installation Guide
Note: The Smart Life app should be installed and registered an account first (Smart Life can be searched in APP Store or Google Play). Then make sure the Gateway is added and online before the next.

Power on the sensor

  1. Open the battery cover

  2. Remove the insulation sheet

Haoliyuan SBLM04 Motion and Brightness Sensor - fig3

Make the device enter pairing mode

Press and hold the button for 5 seconds until the LED blinks.

Device pairing

Open the “Smart Life” app, Enter the gateway homepage and click “Search new device” or “Add Devices” and follow the in-app instructions to connect the device to your gateway.
Waiting for a few seconds, This device is added successfully and you may rename it. Click “Done” to finish the setting. Haoliyuan SBLM04 Motion and
Brightness Sensor - fig6

Device Installation

Close the battery cover then put it where you need it. For a good detection range, the installation height should be 1.82.1 meters. Please refer to the view below to find out the installation place you need.

  1. Top view

  2. Side view

Battery Change

The sensor works with a replaceable CRI.: 3.0V battery. If you received the low bath alarm on the app, please replace the battery and ensure the new battery is installed in the right direction.

Haoliyuan SBLM04 Motion and Brightness Sensor - fig9Haoliyuan SBLM04 Motion and Brightness Sensor -
fig10

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals