ideal lux SP6 Strauss 6Lt Chandelier Gold Instruction Manual
- June 11, 2024
- ideal lux
Table of Contents
ideal lux SP6 Strauss 6Lt Chandelier Gold
Product Information
Specifications
- Model: Strauss SP6
- Max Wattage: 6 x 40W
- Voltage: 220-240V, 50/60Hz
- Manufacturer: IDEAL LUX srl
- Country of Origin: Italy
Product Usage Instructions
Installation
The lighting fitting should be installed by a qualified electrician following the assembly instructions provided.
Safety Instructions
Before starting the installation or any maintenance, always disconnect the power supply. The fixture is equipped with parts that can become hot during operation. Use appropriate screws and plugs for mounting, ensuring compliance with regulations.
Additional Safety Guidelines
- Do not look directly at the light source.
- Ensure compliance with European safety standards (EN 60.598-1).
- In case of damage to the external power cable, it should only be replaced by the manufacturer, retailer, or a qualified electrician.
- The fixture has a fuse; if the lamp does not turn on, replace the fuse.
- Grounding is mandatory for electrical safety.
Classification for Electrical Safety
- Class I: Safety is ensured by the main insulation and a protective conductor (grounding).
- Class II: Safety ensured by double insulation or reinforced insulation; no grounding required.
- Class III: Safety is ensured by very low voltage (below 50 Volts); no grounding is required.
Protection Against Environmental Factors
- The fixture is protected against the entry of solid objects of various diameters and dust particles.
- Ensure the fixture is not exposed to elements that could compromise its protection levels.
Frequently Asked Questions
Q: Can the LED light source be replaced?
A: The LED light source in this fixture is not replaceable. Do not attempt to disassemble the fixture or replace the LED module.
Q: What should I do if the lamp does not turn on?
A: If the lamp fails to turn on, first check and replace the fuse. If the issue persists, contact the manufacturer or a qualified electrician for further assistance.
Q: Is grounding mandatory for this product?
A: Yes, grounding is mandatory to ensure electrical safety.
Follow the instructions provided for proper grounding during installation.
Dimension
Suspension lamp
E14 max 6 x 40W / 220~240V 50/60Hz 8021696140605 ORO
Feature
FOLLOW THE ASSEMBLY INSTRUCTIONS BY READING THE NUMERICAL PROGRESSION THE LIGHTING FITTING SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN
INSTALLATION INSTRUCTION
THE SAFETY AND RELIABILITY ARE GUARANTEED ONLY WHEN INSTALLATION INSTRUCTIONS ARE PROPERLY FOLLOWED. PLEASE KEEP THIS INSTRUCTION SHEET FOR FUTURE REFERENCE.
SAFETY INSTRUCTIONS
- This fitting is produced and tested by the strictest European safety standards (EN 60.598-1).
- This fitting cannot be disposed of as household waste. For disposal information ask the local authorities about how to collect it.
- As indicated by specific regulations, the lighting fitting should be installed by a qualified electrician.
- If the external wire is damaged it has to be replaced exclusively by the manufacturer, distributor or by a qualified electrician.
- Always isolate power before commencing installation, maintenance or repair.
- The luminaire contains certain parts which can be very hot.
- Each material requires specific mounting accessories. Use screws and wall plugs suitable for the material to which they are fastened. Those included may be unsuitable.
- Always tighten the screws firmly to avoid contact problems.
- This fitting should only be installed indoors.
- Luminaires were not suitable for recessed on normally flammable surfaces.
- The luminaire was unsuitable for direct mounting on normal flammable surfaces.
- This fitting is only suitable for fixing the ceiling.
- This fitting is only suitable for fixing the wall.
- The weight of the lamp has to be supported by the chain. Adjust the length of the electric wire so that it is longer than the chain.
- Only use lamps that do not exceed the maximum specified wattage.
- Always observe the minimum distance between the lamp and the surface being lit, as shown in the icon. The lamp can cause a fire if the minimum distance is not observed.
- Auto-protected bulb. Only use bulbs marked with this symbol. Halogen bulbs get very hot. Could you wait until they cool down before replacing it?
- Cracked or broken safety glass has to be replaced immediately. Use only manufacturer-approved parts complying with regulations.
- Light source with not-substitutable light emitting diode (LED). Please don’t disassemble the product since the diodes can damage the eyes. Do not immerse in water. Wipe with a damp cloth. Do not use solvents or strong detergents.
- This fitting is equipped with a fuse. If the lamp is out of order, replace the internal fuse.
- Class I Electrical safety is guaranteed by the main insulation and an additional protective conductor (earthing) connected to the metal frame of the lamp. Earthing is obligatory.
- Class II Electrical safety is guaranteed by the main insulation and double or reinforced insulation. Earthing is not necessary.
- Class Ill Electrical safety is guaranteed by a very low power supply (less than 50 Volts). Earthing excluded.
- Not Protected
- Protected against solid objects greater than 50 mm.
- Protected against solid objects greater than 12 mm.
- Protected against solid objects greater than 2,5 mm.
- Protected against solid objects greater than 1mm.
- Dust protected.
- Protected against dust infiltration.
- Not protected.
- Protected against vertically falling water drops.
- Protected against water drops falling with a maximum angle of 15° to the vertical axis.
- Protected against rain.
- Protected against splashing water.
- Protected against water jets.
- Protected against strong water jets.
- Protected against temporary immersion.
- Protected against prolonged immersion.
- The luminaire was not suitable for covering with thermally insulating material.
- Caution, risk of electric shock.
- Do not stare at the operating light source.
- DEAL LUX s.r.l.
- Via Taglio Destro 32
- 30035 Mirano (VE) Italy
- www.ideal-lux.com
- IDEAL LUX Warehouse
- Via delle Industrie, 8/D
- 30036 Santa Maria di Sala (Venezia)
- 8.00 – 12.00 / 13.30 – 17.00
Documents / Resources
|
ideal lux SP6 Strauss 6Lt Chandelier
Gold
[pdf] Instruction Manual
SP6 Strauss 6Lt Chandelier Gold, Strauss 6Lt Chandelier Gold, Chandelier Gold,
Gold
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>