INSIGNIA NS-SBNC100P9 4K Premium Video/ Power Accessory Cable Quick Setup Guide
- June 8, 2024
- Insignia
Table of Contents
QUICK SETUP GUIDE
4K Premium Video/Power Accessory Cable
NS-SBNC100P9
FEATURES
- All-in-one cable featuring BNC and power connectors
- 100 feet long for more versatile, wide-ranging placement of your security camera
- 4K compatible
- UL/CM-rated
- In-wall installation
- Transmits crisp, clear, high-definition images without interference
PACKAGE CONTENTS
- 4K Premium Video/Power Accessory Cable
- Power adapter
- Quick Setup Guide
SETTING UP YOUR VIDEO/POWER ACCESSORY CABLE
-
Connect your camera’s power/video cables to the BNC connector and power head
on your Video/Power Accessory Cable. -
Connect the BNC connector on the other end of your Video/Power Accessory
Cable to a VIDEO IN jack on your DVR. -
Connect the female power head on the other end of your Video/Power Accessory
Cable to the small connector on your AC power adapter. -
Plug in your AC power adapter.
TROUBLESHOOTING
The audio or video cuts in and out.
- Make sure that all cable connections are correct and secure.
The video has static.
- Make sure that you did not use an adapter or converter with your cables. Plug your
cables directly into your camera and DVR.
My display does not show 4K content.
- Make sure that your camera and DVR are able to record 4K content.
- Make sure that your display supports 4K content.
SPECIFICATIONS
- Cable length: 100 ft. (30.5 m)
- Cable diameter (OD): 0.11 x 0.22 in. (2.8 x 5.8 mm)
- Cable bending radius: R>10D (D=cable diameter)
- Operating temperature: -4° ~ 140°F (-20° ~ 40°C)
- Storage temperature: -4° ~ 140°F (-20° ~ 40°C)
- Interface: BNC Male to BNC Male
- Maximum resolution: 4K
- In-wall Installation: UL Certified, CM
SAFETY INFORMATION
- Read these instructions.
- Never pull on the cable to disconnect the connector end from a source or display.
- Do not bend your Video/Power Accessory cable too far. The bending radius at any point on your Video/Power Accessory cable must be more than .8 in. (20 mm).
- Do not expose your Video/Power Accessory cable to water.
- Do not use excessive force when installing your Video/Power Accessory cable.
- Do not install near any heat sources such as radiators, heat registers, stoves, or other devices (including amplifiers) that produce heat.
- Do not store your Video/Power Accessory cable in an extremely cold, warm, or humid environment.
- Do not dismantle your Video/Power Accessory cable.
LEGAL NOTICES
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
FCC Caution
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, maybe cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
ICES statement: CAN ICES-3 B/NMB-3 B
ONE-YEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA
For customer support, call
1-877-467-4289 (U.S. and Canada) or
01-800-926-3000
(Mexico)
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its affiliated companies
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richfield, MN 55423 U.S.A.
©2018 Best Buy. All rights reserved.
Made in China
INSIGNIA NS-SBNC100P9 4K Premium Video/ Power Accessory Cable Quick Setup Guide – Download
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>