Homedics WF-MN-OAS EnviraScape Mini Oasis Tabletop Relaxation Fountain Instruction Manual and Warranty Information

: June 8, 2024
: Homedics

Table of Contents

One Year Limited Warranty (Valid in USA only)
The sounds of mother nature soothe human nature
EnviraScape Features
IMPORTANT SAFETY INSTRUCTIONS:
Caution:
SAVE THESE INSTRUCTIONS
Assembly and Instructions for Use
Maintenance:
Troubleshooting:
Mail to:
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

One Year Limited Warranty (Valid in USA only)

HoMedics, Inc., guarantees this product free from defects in material
and workmanship for a period of one year from the date of purchase,
except as noted below.
This HoMedics product warranty does not cover damage caused by
misuse or abuse, accident, the attachment of any unauthorized
accessory, alteration to the product, or any other conditions
whatsoever that are beyond the control of HoMedics. This warranty is
effective only if the product is purchased and operated in the USA. A
product that requires modification or adaptation to enable it to operate
in any country other than the country for which it was designed,
manufactured, approved and/or authorized, repair of products
damaged by these modifications is not covered under warranty.
HoMedics shall not be responsible for any type of incidental,
consequential or special damages. All implied warranties, including
but not limited to those implied warranties of fitness and
merchantability, are limited in the total duration of one year from the
original purchase date.
To obtain warranty service on this product, either hand deliver or mail
the unit and your dated sales receipt (as proof of purchase), postpaid,
along with a check or money order in the amount of $10.00 payable to
HoMedics, Inc. to cover handling.
Upon receipt, HoMedics will repair or replace, as appropriate, the
product and return it to you, postpaid. Warranty is solely through
HoMedics Service Center. Service of this product by anyone other
than HoMedics Service Center voids warranty.
This warranty provides you with specific legal rights. You may have
additional rights which may vary from state to state. Because of
individual state regulations, some of the above limitations and
exclusions may not apply to you.
For more information regarding our product line in the USA, please visit:
www.homedics.com

The sounds of mother nature soothe human nature

Thank you for purchasing the HoMedics’ EnviraScape Mini Oasis
Tabletop Relaxation Fountain. Like the entire line of HoMedics products,
it is built with high-quality craftsmanship to provide you with
years of dependable service. We hope you find it to be the finest
product of its kind.
EnviraScape enables you to create an all-encompassing environment
with sound. The sound of flowing water enhances your environment by
releasing negative ions, and promoting relaxation. Only EnviraScape
offers you the luxury of these vital benefits. Through its creative design,
beauty is added to any indoor environment.

EnviraScape Features

Innovative, Artistic Design
Enhances the environment at home or at work.
Variable Water Flow Speeds
Controls the speed that meets your mood.
Durable Electrical Water Pump
Can be operated from any indoor 120 volt A/C electrical outlet.
Easy to Assemble
Assembles in minutes with simple, illustrated instructions.

IMPORTANT SAFETY INSTRUCTIONS:

When using an electrical appliance, basic precautions should
always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING

DANGER – To reduce the risk of electric shock:

Always unplug the appliance from the electrical outlet immediately
after using and before cleaning.
Do not reach for an appliance that has fallen into water. Unplug it
immediately.
Do not place or store appliance where it can fall or be pulled into a
tub or sink. Do not place in or drop into water or other liquid.
To reduce the risk of electric shock, connect only to a 120 volt A/C
household outlet. Do not connect to any voltage other than that
shown on the pump.
Do not pump flammable liquids through the water pump.
Do not use water above 86 degrees Fahrenheit.

Caution:

The pump must be completely submerged in water. If the
pump is making noises, most likely it is not completely submerged
in water

WARNING – To reduce the risk of burns, fire, electric shock or
injury to persons:

An appliance should never be left unattended when plugged in.
Unplug unit from outlet when not in use and before putting on or
taking off parts or attachments.
Close supervision is necessary when this appliance is used by or
near children, invalids or disabled persons.
Use this appliance only for its intended use as described in this
manual. Do not use attachments not recommended by HoMedics,
specifically any attachment not provided with the unit.
Do not operate this appliance if it has a damaged cord or plug, if it
is not working properly, if it has been dropped or damaged, or if
the cord has been dropped into water. Return it to the HoMedics
Service Center for examination and repair.
Keep cord away from heated surfaces.
Never drop or insert any object into any opening unless otherwise
directed in this instruction manual.
Do not operate where aerosol spray products are being used or
where oxygen is being administered.
Do not carry this appliance by the electrical cord or use the cord
as a handle.
To disconnect, remove plug from outlet.
This appliance is designed for indoor use only. Do not use outdoors.

Caution:
Only set the fountain and fountain parts on waterproof surfaces

SAVE THESE INSTRUCTIONS

Caution – Please read all instructions
carefully before operating.

Never leave appliance unattended while operating the unit,
especially if children are present.
Never cover unit when it is in operation.
Connect the pump only to 120 volt A/C household outlet as
indicated on the pump label.
Always keep the cord away from high temperatures.
Unplug the water pump from the power source before cleaning,
performing maintenance, or disassembling.
To get the most efficient flowing effect, product must be placed on
a level and sturdy surface before using, and should not be placed
on any type of electrical appliance.
Never let the water pump run without water. This will shorten the
life of the pump.
Operate with freshwater (tap water) only. The pump is not
equipped to run with saltwater (sea water).
Operate pump completely submerged for proper cooling.
The electrical cord of this product cannot be replaced. If it sustains
damage, you must stop using the appliance immediately and
return it to the HoMedics Service Center for examination and
repair. (See the warranty section for HoMedics address).
Disconnect the appliance from the electrical outlet before putting
hands into water.

Assembly and Instructions for Use

Remove all contents from packaging and inspect to make sure
all components have been received (Fig. 1):
• Base with attached electrical cord and water pump
• Fountain top
• Polished river rocks
• A/C Adaptor
Wipe any dust off the interior and exterior of the base and top
and rinse river rocks under water.
Familiarize yourself with the pump. The pump speed is
controlled by the dial located at the front of the pump. The speed
is indicated by a “-” and “+”. To increase the speed, move the
dial downward in the direction of the “+”. At its highest speed
level, the dial will cease to move any further. To decrease the
pump speed, move the dial upward toward the “-”. Similarly, at
its lowest speed, the dial will cease to move any further (Fig. 2). NOTE: It is recommended the pump be set at its
highest speed during assembly and later adjusted
to a lower setting if desired. Be sure to unplug the
pump before adjusting the speed setting.
Place the fountain base on a sturdy, level surface
in the desired location, ensuring its electrical cord
will sufficiently reach an electrical outlet. Once
assembled, the fountain may be difficult to move
due to splashing. Once in the desired location,
lead the power cord attached to the base through
the notch at the bottom of the base to ensure the
base sits level without wobbling. Attach the A/C
adaptor jack to the base power cord. Do NOT plug
in at this time (Fig. 3).
Add clean water to the base until the water level
is 1/2” to 3/4” below the rim.
Connect the PVC tube to the pump, adjust the
pump speed and place the fountain top on the base (Fig. 4).
Place the fountain top on to the base and then
arrange the polished river rocks around the
fountain top. (Be sure not to place any rocks
inside the base of the fountain).
Plug the A/C adaptor into a 120V household outlet.
The fountain is controlled by the switch located on
the power cord. If pump doesn’t operate, rotate inline
switch once to turn “on” and once more to turn
“off”.
NOTE: If you can hear the pump gurgling or making
sounds, you have not added enough water to cover
(submerge) the pump.
It will be necessary to add water occasionally due
to evaporation.
NOTE: Always add water when fountain is “OFF”
to avoid overflow.

Maintenance:

To clean the pump:
Unplug the fountain from the electrical outlet. Remove the
pump from the base of the fountain. Use a small brush or
stream of water to remove any debris.
To keep water clean:
Periodically change the water and clean the product according
to the water condition. Keeping the water clean prevents the
water from becoming sticky and forming micro-organisms. An
algaecide or humidifier/vaporizer treatment can be added to
help keep it clean.
To clean hard water deposits from
the base or rocks:
Soak the base and rocks in a mixture of vinegar and water to
clean and remove any mineral build-up.
Keeping the water at an optimum level:
Add water periodically to keep water level at an optimum level
to avoid shortening the life of the water pump. Fountain
should be “OFF” when refilling to avoid overflow.
NOTE: Never let the water pump run without water. This will
also shorten the life of the water pump.
Fountain Storage:
When not in use for long periods of time, unplug the fountain
from the electrical outlet, empty the water and store in a cool,
dry place.

Homedics WF-MN-OAS EnviraScape Mini Oasis Tabletop Relaxation Fountain
Instruction Manual and Warranty Information

Troubleshooting:

If the pump fails to operate, check
the following:
Check the household circuit breaker or plug unit into a different
outlet to make sure the water pump is getting electrical power.
NOTE: Always disconnect the unit from the electrical outlet
before handling the water pump.
Check the water pump discharge and tubing for kinks and
obstructions. Algae build-up can be flushed out in any faucet.
Remove the water pump inlet to access the impeller area. Turn
the impeller to ensure it is not broken or jammed.
Monthly maintenance will add to the life of your water pump.
NOTE: Make sure that the electrical cord loops below the electrical
outlet to form a “drip loop”. This will prevent water from running
down the cord into the electrical outlet (Fig.5).
If the pump is loud, gurgles, spews, or “burps”:
Check the water level to make sure the water pump has enough
water to function.
NOTE: The pump must be completely submerged in water.
Obtaining a desired water level:
Check the water level daily in the first week to measure the
rate of evaporation. Refill with water as needed.
If water is flowing unevenly:
Check to see if the fountain is on a level surface. Then, run
fingersacross fountain surface to help spread the water distribution.