FlySky FS-iA8X Receiver Information Manual

FlySky FS-iA8X Receiver Information Manual

Introduction

The FS-iA8X is a single antenna bidirectional receiver using the AFHDS 2A (Second Generation Automatic Frequency Hopping Digital System) protocol. It’s compact, easy to install and can output using a standard PPM or i-BUS signal.

Receiver overview

Ports

These ports connect the receiver to various models, component’s and flight controllers.

PPM signal port: Outputs standard PPM signal.

i-BUS signal port: Outputs i-BUS signal.

VCC: Power supply voltage from 4.0 – 8.4V.

GND: Connect to ground wire.

• Attention:

Make sure the product is installed and calibrated correctly, failure to do so may result in serious injury.

Make sure the receiver’s battery is disconnected before turning off the transmitter, failure to do so may lead to unintended operation or loss of control.

Make sure the receiver is mounted away from motors, electronic speed controllers or any device that emits excessive electrical noise.

Keep the receiver’s antenna at least 1cm away from conductive materials such as carbon or metal.

Do not power on the receiver during the setup process to prevent loss of control.

Binding

1. First put the transmitter into bind mode (see the transmitter’s user manual for instructions on how to activate bind mode.)
2. Connect the receiver to power, after 1 second the receiver’s LED will start to flash indicating that it has entered bind mode.
3. When the receiver’s LED stops flashing the transmitter and receiver have successfully bound.
4. Check to make sure that the transmitter and receiver are working as expected, if there are any issues or unexpected operation follow the steps above to bind again.

Product specification

• Channels: 8
• Model Type: Multi Rotor
• Data Output: PPM/i-BUS
• Frequency Range: 2.408-2.475GHz
• Bandwidth: 500KHz
• Number of Bands: 135
• Transmission Power: <20dBm
• Receiver Sensitivity: – 92dBm
• 2.4GHz Protocol: AFHDS 2A
• Modulation: GFSK
• Transmission Method: FHSS
• Channel Latency: <15ms
• Antenna: Single Antenna
• Input Power: 4.0-8.4V
• Display: LED Indicator
• Online Update: None
• Range without interference 1 m from the ground : more than 200m Channel Data: 1500us ; Range : 1000~2000us
• Dimensions: 15133mm
• Weight: <2g
• Certification: CE , FCC

FlySky FS-iA8X Receiver Information Manual – Download [optimized]
FlySky FS-iA8X Receiver Information Manual – Download

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>