Cabinet Lock Replacement and Wheel Assembly Instructions

June 8, 2024
Hirsh Industries

Cabinet Lock Replacement and Wheel Assembly

Lock Replacement Instructions

Note: Do not place your fingers behind or slide your fingers along the sheet metal edges.

To remove the old lock
  1. Open the drawer and locate the Wing Clips which hold the lock in place. (Figure 1)Figure 1
  2. With a flathead screwdriver push the Wing Clips toward the lock body and push the lock body forward until the Wing Clip on that side is slightly protruding out of the drawer front.
  3. Again using the flathead screwdriver push the Wing Clip on the other side toward the lock body and push forward until the lock can be removed from the drawer.
To install the new lock:
  1. Make sure that the cam is in the unlocked position by turning the key counterclockwise as far as it will go.

  2. Feed the lock cam through the hole in the drawer front so the Lock Cam is pointing
    toward the center of the drawer (Figure 2) and align the Wing Clips with the notches in the drawer front (Figure 3).Figure 2Figure 3

  3. Push the lock into the drawer front until the Wing Clips pass through the drawer front and snap into place behind the drawer front (Figure 4).Figure 4

HANGING FOLDER SUPPORT INSTALLATION

This filing cabinet can be used with hanging file folders by simply installing two folder supports per drawer as follows:

Step 1:

Slide the drawer half way out of the cabinet to allow access to the drawer sides.
Identify the two small square tabs on each side of the drawer near the front. (See Figure 1).

Step 2:

From the outside of the drawer, push the tabs inward until they are at a 90 degree angle to the drawer side. (See Figure 2).

Step 3:

Install one folder support into each drawer side through the top holes and then
through the square tab. (See Figure 2).

Note: After the installation of the support, the bend in the support should remain above the top of the drawer and should point toward the center of the drawer.

Step 4:

Place several hanging folders in the drawer to ensure proper support positioning.

Step 5:

Repeat steps 1-4 for each drawer.

Caster Kit

BEFORE YOU BEGIN
Open, identify and count all parts prior to assembly.

A. (2) Front Caster
B. (2) Rear Caster
C. (8) Screw
D. (2) Caster Bracket

Caster Kit

STEP 1 – Attach Front Casters:

Align screw holes in front caster mounting plate with the screw holes in the bottom of cabinet. Connect the Front Casters (A) with Screws (C) using a phillips screwdriver. Fully tighten all screws.Mounting

STEP 2 – Attach Rear Casters:

Position v-bends of Caster Bracket (D) up under cabinet rims.

Align screw holes in rear caster mounting plate with screw holes in Caster Bracket (D) ensuring the mounting plate covers the bottom corner of the cabinet. (Figure 4).

Connect the Rear Caster (B) and the Caster Bracket (D) with Screws (C) using a phillips screwdriver. Fully tighten all screws.Rear
Caster

Step 3:

Complete assembly.Assembly

Step 4:

Close-up of rear caster assembly.Caster

West Des Moines, Iowa                  www.hirshindustries.com 1-800-383-7414

Cabinet Lock Replacement and Wheel Assembly Instructions – Download [optimized]
Cabinet Lock Replacement and Wheel Assembly Instructions – Download

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals