HIGH TECH PET MS-5 Electronic Pet Collar Instruction Manual
- September 24, 2024
- HIGH TECH PET
Table of Contents
HIGH TECH PET MS-5 Electronic Pet Collar
Specifications
- Product Name : MS-5 Electronic Pet Collar
- Manufacturer: HighTechPet
- Activation Method: Electronic
- Battery Type : MS-5 Battery
- Positioning: Bottom of pet’s neck, facing down
Product Usage Instructions
Activating Your MS-5 Electronic Pet Collar
- Make sure to read all instructions carefully before proceeding.
- Activate the electronic collar following the provided guidelines.
Fitting the MS-5 Electronic Collar on Your Dog
- Position the collar at the bottom of your pet’s neck.
- Ensure the electronics are facing down for proper functionality.
- This positioning is crucial for triggering the door and barriers correctly.
Installing/Replacing the MS-5 Battery
- Follow the manufacturer’s instructions for installing or replacing the MS-5 battery.
- Make sure to use the correct type of battery for optimal performance.
OPERATING INSTRUCTIONS
Please Read All Instructions Carefully
-
Activating Your MS-5 Electronic Pet Collar
NOTE : the B3V1A Battery (pictured right) is the ONLY battery that is compatible with the MS-5 collar. Do not attempt to use any other battery in the MS-5 collar.
NOTE: Some collars are shipped with a battery pre-installed.
If the battery is not already pre-installed in the collar, install the battery by following the instructions on the next page. -
Fitting the MS-5 Electronic Collar on Your Dog
-
Place the collar on your pet with the electronics at the throat as shown.
-
When properly fitted, the receiver collar should not move on the dog, but also should not be overly tight. You should be able to fit your fingers between the strap and your pet’s neck.
Replacement B3V1A batteries are available at www.HighTechPet.Com
INSTALLING/ REPLACING THE MS-5 BATTERY
- Unscrew the bottom cover,
- Pry the bottom off at the location shown here, using a small flat-blade screw-driver or metal nail file.
- Remove the bottom, note the battery orientation
- Remove and replace B3V1A battery
- With a new battery installed, close the case. Squeeze until the bottom is flush with the top, by squeezing the top and bottom together.
- Insert and tightest the crew.
MAINTAINING THE WATERPROOF SEAL
The waterproof seal will last for years if you keep the gasket clean when replacing the battery. Here are some suggestions for extending the life of your collar.
- Clean the bottom edge of the collar before opening the case toreplace a battery. Also thoroughly dry the collar before opening it. A blow dryer can be used.
- After opening the case, clean any visible dirt off the inside lip of the case and the gasket on the bottom cover. Finally blow off any remaining lint or fibers. Then insert the battery and close it up.
- Keep the inside of the collar dry. Each time you open it look for water or moisture inside. If detected, remove the battery and use a blow dryer on the circuit board.
Caution : As with any pet door, supervision of your pet is advised. Failure to do so could result in harm to your pet. Please be sure to provide water and shade outside in the rare event that the electronic door fails to open.
High Tech Pet Products, Inc. 2111 Portola Rd, Suite A Ventura, CA 93003
www.hightechpet.com
FAQ
- Q: How often should I replace the battery in the MS-5 Electronic Pet Collar?
- A: The battery life may vary based on usage, but it is recommended to check and replace the battery as needed to ensure uninterrupted functionality.
- Q: Can the MS-5 Electronic Pet Collar be used on pets of all sizes?
- A: The MS-5 Electronic Pet Collar is designed to be adjustable and suitable for pets of various sizes, but it is essential to ensure proper fitting and positioning for effective operation.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>