ITC Acute Flex Light Instruction Manual
- June 3, 2024
- ITC
Table of Contents
ITC Acute Flex Light
PARTS / TOOLS NEEDED
- Acute Tape Light
- UL Approved Power Supply (optional)
- Butt Splices (not provided)
- Alcohol Wipes (not provided)
Safety Instructions
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- Do not install any luminaire assembly closer than 6” from any combustible materials.
- Lights are not rated for wet location installation.
- Note, this light is susceptible to damage by electrostatic discharge, use care when handling.
- For safety purposes, ITC recommends tape light installations be used with a Class 2 power device. For installations without a Class 2 power device, it is highly recommended that appropriate fusing be used, to be determined by tape light length.
INSTALLATION
- Determine the installation location and clean the surface using alcohol wipes (not provided). For more information on surface prep please review the 3M website*. Start at the wired end and begin peeling back the tape.
- Press the light in place. Continue working along the light and peel the paper as you go. Only pull back a few inches at a time to prevent the tape light sticking to itself. The light can be bent at 90°, but should only be bent as shown below. Bending on the LEDs or smaller curves could result in damage to the light.http://www.3m.com/3M/en_US/bonding-and-assembly-us/resources/full-story/?storyid=b3996cbd-9954-455f-8e72-88e452ca38c0
- Follow the wiring diagram below to wire the light to your system
3030 Corporate Grove Dr. Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
For warranty information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00030 • Rev A • 09/11/17
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>