QAZQA Bergamo WL Satin Black Instruction Manual
- June 7, 2024
- QAZQA
Table of Contents
INSTRUCTION MANUAL
Bergamo WL Satin Black
90247
SAFETY INSTRUCTION
Please study the instruction manual and below information carefully before installing or using this product. Please keep this user manual for further reference
-
The luminaires may only be installed by authorized and qualified technicians according to the valid regulations for electrical installation.
-
Maintenance of the luminaires is limited to their surfaces. During maintenance, no moisture can come into contact with any areas of the terminal connections or voltage control parts.
-
The electrical supply must be switched off at the outset, preferably by means of a switch in the distribution box, before any installation, maintenance or repair work is undertaken.
-
Exterior lighting must not be installed during rain.
-
Take account of the minimum separation distance from other objects and the room required around the fitting.
-
If in any doubt, consult a professional, taking local installation requirements into account. Some countries stipulate that lighting may be installed only by registered installers.
-
Clamping screws in electrical connections must be adequately tightened. This is particularly the case with 12V low voltage conductors.
-
When replacing a halogen lamp, wait for it to cool, for a minimum of 5 minutes.
-
Clean with a clean, dry cloth or brush, use no solvents or abrasives. Avoid dampness on all electrical components
-
Take account of all available technical information.
-
Take note of the symbols when connecting wires:
N =Neutral L =Live =Earth -
Meaning of symbols:
For indoor use
only, where direct contact with water is impossible
This icon
indicates the level of water-proof and dust-proof
Protection Class
I: the fitting must be earthed
Protection Class
II: the fitting is doubled insulated and does not require earthing
Protection Class
III: the fitting is low voltage
Minimum distance
from lighted objects (meters)
Only the self-
shielded halogen lamp should be used with the luminaire
Strip the wire to
the indicated length (mm)
Connect using the
specified cable
The luminaire is
suitable for direct mounting on a normal inflammable surface
The type of lamp
and maximum size and wattage indicated in each lighting unit must not be
exceeded
The armature is
designed to work only with the indicated voltage. Different items require
different working volta
The luminaire can
be used in combination with a dimmer
The reference
light angle and light space of the luminaire
This luminaire
cannot be disposed of together with normal domestic waste in standard rubbish
can, but you have to bring it to a staging area for electrical waste
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>