BOSCH DUL63CC60B Extractor Hood Instruction Manual

: June 4, 2024
: Bosch

BOSCH DUL63CC60B Extractor Hood

BOSCH DUL63CC60B Extractor Hood product LLL

Important safety information

Only then will you be able to operate your appliance safely and correctly.
The appliance can only be used safely if it is correctly installed according to the safety instructions.
The installer is responsible for ensuring that the appliance works perfectly at its installation location.
This appliance is intended for domestic use and the household environment only.
The appliance is not intended for use outside.
Do not leave the appliance unattended during operation.
The manufacturer is not liable for damage which is caused by improper use or incorrect operation.
This appliance is intended for use up to a maximum height of 2000 meters above sea level.
This appliance is not intended for use by persons including children with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children must not play with, on, or around the appliance.
Children must not clean the appliance or carry out general maintenance unless they are at least 8 years old and are being supervised.
Keep children below the age of 8 years old at a safe distance from the appliance and power cable.
Check the appliance for damage after unpacking it.
Do not connect the appliance if it has been damaged in transport.
This appliance is not intended for operation with an external clock timer or a remote control.

Danger of suffocation

Packaging material is dangerous to children. Never allow children to play with packaging material.

Danger of death
Risk of poisoning from flue gases that are drawn back in. Always ensure adequate fresh air in the room if the appliance is being operated in exhaust air mode at the same time as room air-dependent heat-producing appliance is being operated.

BOSCH DUL63CC60B Extractor Hood 1

Room air dependent heat-producing appliances e.g. gas, oil, wood or coal operated heaters, continuous flow heaters or water heaters obtain combustion air from the room in which they are installed and discharge the exhaust gases into the open air through an exhaust gas system e.g. a chimney.In combination with an activated vapor extractor hood, room air is extracted from the kitchen and neighboring rooms a partial vacuum is produced if not enough fresh air is supplied. Toxic gases from the chimney or the extraction shaft are sucked back into the living space.

Adequate incoming air must therefore always be ensured.
An incoming/exhaust air wall box alone will not ensure compliance with the limit.
Safe operation is possible only when the partial vacuum in the place where the heat-producing appliance is installed does not exceed 4 Pa (0.04 mbar).
This can be achieved when the air needed for combustion is able to enter through openings that cannot be sealed, for example in doors, windows, incoming/exhaust air wall boxes or by other technical means.

BOSCH DUL63CC60B Extractor Hood 2

In any case, consult your responsible Master Chimney Sweep.
He is able to assess the house’s entire ventilation setup and will suggest the suitable ventilation measures to you.
Unrestricted operation is possible if the vapour extractor hood is operated exclusively in the circulating air mode.

Risk of fire

Grease deposits in the grease filter may catch fire.
Clean the grease filter at least every 2 months.
Never operate the appliance without the grease filter.
Grease deposits in the grease filter may catch fire.
Never work with naked flames close to the appliance e.g. flambéing.
Do not install the appliance near a heat-producing appliance for solid fuel e.g. wood or coal) unless a closed, non removable cover is available.
There must be no flying sparks.
Hot oil and fat can ignite very quickly.
leave hot fat or oil unattended. Never use water to put out burning oil or fat. Switch off the hotplate.
Extinguish flames carefully using a lid, fire blanket or something similar.
When gas burners are in operation without any cookware placed on them, they can build up a lot of heat.
A ventilation appliance installed above the cooker may become damaged or catch fire.
Only operate the gas burners with cookware on them.
Operating several gas burners at the same time gives rise to a great deal of heat.
A ventilation appliance installed above the cooker may become damaged or catch fire.
Never operate two gas burners simultaneously on the highest flame for longer than 15 minutes.
One large burner of more than 5 kW (wok) is equivalent to the power of two gas burners.

Risk of burns
The accessible parts become very hot when in operation. Never touch hot parts. Keep children at a safe distance.

Risk of injury

Components inside the appliance may have sharp edges.
Wear protective gloves. Items placed on the appliance may fall down.
Do not place any objects on the appliance.
The light emitted by LED lights is very dazzling, and can damage the eyes risk group.
Do not look directly into the switched on LED lights for longer than 100 seconds.

Risk of electric shock
A defective appliance may cause electric shock. Never switch on a defective appliance. Unplug the appliance from the mains or switch off the circuit breaker in the fuse box. Contact the after-sales service.Incorrect repairs are dangerous. Repairs may only be carried out and damaged power cables replaced by one of our trained after-sales technicians. If the appliance is defective, unplug the appliance from the mains or switch off the circuit breaker in the fuse box. Contact the after-sales service.Do not use any high-pressure cleaners or steam cleaners, which can result in an electric shock.

Causes of damage
Caution
Risk of damage due to corrosion

Always switch on the appliance while cooking to avoid condensation. Condensate can produce corrosion damage.
Risk of damage due to ingress of humidity into the electronic circuitry. Never clean operator controls with a wet cloth.
Surface damage due to incorrect cleaning. Clean stainless steel surfaces in the direction of the grain only. Do not use any stainless steel cleaners for operator controls.
Surface damage due to strong or abrasive cleaning agents. Never use strong and abrasive cleaning agents.
Risk of damage from returning condensate. Install the exhaust duct in such a way that it falls away from the appliance slightly (1° slope).

Environmental protection

Your new appliance is particularly energy-efficient. Here you can find tips on how to save even more energy when using the appliance, and how to dispose of your appliance properly.

Saving energy

During cooking, ensure that there is a sufficient supply of air so that the extractor hood can work efficiently and with a low level of operating noise.
Adjust the fan speed to the intensity of the cooking fumes.
Only use intensive mode where this is required.
A lower fan speed means that less energy is consumed.
If there are intensive cooking fumes, select a higher fan speed in good time.
If cooking fumes have already spread in the kitchen, the extractor hood must be operated for longer.
Switch off the extractor hood if you no longer require it.
Switch off the lighting if you no longer require it.
Clean and, if required, replace the filter at regular intervals in order to increase the effectiveness of the ventilation system and to prevent the risk of fire.

Environmentally friendly disposal of packaging in an environmentally

friendly manner

This appliance is labelled in accordance with European Directive 2012/19/EU concerning used electrical and electronic appliances (waste electrical and electronic equipment WEEE. The guideline determines the framework for the return and recycling of used appliances as applicable throughout the EU.

Operating modes

This appliance can be used in exhaust-air mode or circulating-air mode.

Exhaust air mode

The air which is drawn in is cleaned by the grease filters and conveyed to the exterior by a pipe system.

Note
The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room. Before conveying the exhaust air into a non-functioning smoke or exhaust gas flue, obtain the consent of the heating engineer responsible. If the exhaust air is conveyed through the outer wall, a telescopic wall box should be used.

Operating the appliance

These instructions apply to several appliance variants. It is possible that individual features are described which do not apply to your appliance.

Note
Switch on the extractor hood when you start cooking and switch it off again several minutes after you have finished cooking. This is the most effective way of removing the kitchen fumes.
Fold the glass cover forwards. This increases the extraction area.

Control panel

BOSCH DUL63CC60B Extractor Hood 3

Explanation

Setting the fan

Note
Always adjust the fan strength to meet current conditions. If there is a large build-up of steam or fumes, select a high fan setting.

Switching on

Press the A button.
Note: If the fan is switched on, an LED lights up.
The fan starts up at the speed to which it was last set.
Press the 2 or 3 button to set another fan speed.

Switching off

Press the A button.

Lighting

lighting can be switched on and off independently of the ventilation.
Press the 6 button.

Cleaning and maintenance

Risk of burns
The appliance becomes hot during operation. Allow the appliance to cool down before cleaning.

Risk of electric shock
Penetrating moisture may result in an electric shock. Clean the appliance using a damp cloth only. Before cleaning, pull out the mains plug or switch off the circuit breaker in the fuse box.

Risk of electric shock
Do not use any high-pressure cleaners or steam cleaners, which can result in an electric shock.

Risk of injury
Components inside the appliance may have sharp edges. Wear protective gloves.

Cleaning agents

To ensure that the different surfaces are not damaged by using the wrong cleaning agent, observe the information in the table. Do not use any of the following:

Harsh or abrasive cleaning agents,
Cleaning agents with a high alcohol content,
Hard scouring pads or cleaning sponges,
High pressure cleaners or steam cleaners.
Wash new sponge cloths thoroughly before use.

Follow all instructions and warnings included with the cleaning agents.

Stainless steel

Cleaning agent

Hot soapy water Clean with a dish cloth and then dry with a soft cloth.
Clean stainless steel surfaces in the grind direction only.
Special stainless steel cleaning prod-ucts are available from our after sales service or from specialist retailers.
Apply a very thin layer of the cleaning product with a soft cloth.

Painted surfaces

Hot soapy water

Clean using a damp dish cloth and dry with a soft cloth/towel.
Do not use any stainless steel cleaners.

Aluminum and plastic

Glass cleaner
Clean with a soft cloth.

Glass

Glass cleaner
Clean with a soft cloth. Do not use a glass scraper.

Controls

Hot soapy water

Clean using a damp dish cloth and dry with a soft cloth/towel.
Risk of electric shock caused by penetrating moisture.
Risk of damage to the electronics from penetrating moisture.
Never clean operating controls with a wet cloth.
Do not use any stainless steel cleaners.

Cleaning the metal mesh grease filters

These instructions apply to several appliance variants. It is possible that individual features are described which do not apply to your appliance.

Risk of fire

Grease deposits in the grease filter may catch fire.
Clean the grease filter at least every 2 months.
Never operate the appliance without the grease filter.

Notes

Do not use any aggressive, acidic or alkaline cleaning agents.
When cleaning the metal mesh grease filters, also clean the holder for the metal mesh grease filters in the appliance using a damp cloth.
The metal mesh grease filters can be cleaned in the dishwasher or by hand.

By hand

Note
You can use a special grease solvent for stubborn dirt. It can be ordered via the Online Shop.

Soak the metal mesh grease filters in a hot soapy solution.
Clean the filters with a brush and then rinse them thoroughly.
Leave the metal mesh grease filters to drain.

In the dishwasher

Note
If the metal mesh grease filters are cleaned in the dishwasher, slight discoloration may occur. This has no effect on the function of the metal mesh grease filters. Do not clean heavily soiled metal mesh grease filters together with utensils. Place the metal mesh grease filters loosely in the dishwasher. The metal mesh grease filters must not be wedged in.

Removing metal grease filter

Push the lock and then push the metal grease filter back and pull it down. While doing this, place your other hand under the metal greas as filter.

Note
To avoid causing damage, do not bend the metal grease filter.

Take the metal grease filter out of the holder.

Note
Grease may accumulate in the bottom of the metal grease filter. Hold the metal grease filter level to prevent grease from dripping out. After removing the metal grease filters, clean the inside of the appliance. Clean the metal grease filters and let them dry before re-fitting them.

Installing the metal mesh grease filter

Insert the metal mesh grease filter.
While doing this, place the other hand under the metal mesh grease filter.
Fold the metal mesh grease filter upwards, locking it in place.

Changing the activated charcoal filter only in circulating-air mode

In order to guarantee efficient odor filtration, the filter must be serviced regularly.
The activated charcoal filters must be replaced at least every 4 months.

Notes

The activated charcoal filters are not included in the delivery.
The activated charcoal filters can be obtained from specialist retailers, from our after-sales service or from the Online Shop.
The activated charcoal filters cannot be cleaned or reactivated.

Note
Only use genuine replacement filters. This ensures optimal performance of the appliance.

Remove the metal grease filter, see the chapter Removing the metal grease filter.
Undo the threaded joint on the activated charcoal filter cover.
Remove the activated charcoal filter.
Insert the activated charcoal filter.
Screw the cover in place.
Install the metal grease filter, see the chapter Installing the metal grease filter.

Trouble shooting

Malfunctions often have simple explanations. Please read the following notes before calling the after-sales service.

Risk of electric shock
Incorrect repairs are dangerous. Repairs may only be carried out and damaged power cables replaced by one of our trained after-sales technicians. If the appliance is defective, unplug the appliance from the mains or switch off the circuit breaker in the fuse box. Contact the after sales service.

Fault table

BOSCH DUL63CC60B Extractor Hood table

Replacing the LED lights

Risk of electric shock
When changing the bulbs, the bulb socket contacts are live. Before changing the bulb, unplug the appliance from the mains or switch off the circuit breaker in the fuse box.

Risk of injury
The light emitted by LED lights is very dazzling, and can damage the eyes risk group 1.Do not look directly into the switched on LED lights for longer than 100 seconds.

Important
Only use bulbs of the same type and wattage.

Lift the bulb cover slightly and move it towards the outside of the appliance.
Unscrew the bulb and replace it with a bulb of the same type.

BOSCH DUL63CC60B Extractor Hood 9

Fit the bulb cover. Plug in the mains plug and switch the fuse back on.

After sales service

Our after sales service is there for you if your appliance needs to be repaired. We will always find the right solution in order to avoid unnecessary visits from a service technician. When calling us, please give the product number E no and the production number FD no so that we can provide you with the correct advice. The rating plate with these numbers can be found inside the appliance remove the metal mesh grease filter to gain access. You can make a note of the numbers of your appliance and the telephone number of the after- sales service in the space below to save time should it be required. Please be aware that a visit by an after-sales engineer will be charged if a problem turns out to be the result of operator error, even during the warranty period. Please find the contact data of all countries in the enclosed customer service list. To book an engineer visit and product advice GB 0344 892 8979

IE
Calls charged at local or mobile rate 01450 2655 0.03 € per minute at peak. Off peak 0.0088 € per minute.

Rely on the professionalism of the manufacturer. You can therefore be sure that the repair is carried out by trained service technicians who carry original spare parts for your appliances.