dlink Full HD Outdoor Wi-Fi Camera Instruction Manual
- June 7, 2024
- dlink
Table of Contents
DCS-
8600LH
Full HD Outdoor Wi-Fi Camera
Quick Installation Guide
Download the App
Search for
mydlink and download the app.
Note : This product is incompatible with other mydlink apps such as
‘mydlink Home,’ ‘mydlink Lite,’ etc.
Log In
Sign In or Sign Up for a mydlink account. mydlink Lite users may sign in with the same account.
Add the Device
- Tap the menu button Ξ
- Tap Add a Device
- Scan the Setup Code on the power cable or on the Quick Install Card, then follow the app instructions
Precautions
Caution:
Please make
sure that the camera is not directly facing the sun or a source of heat.
Proper Placement:
Place the camera at least 8 feet or higher from the ground. The maximum motion
detection distance is 16 feet.
Improper Placement:
Do not place the camera directly on top of a surface or in a spot where there
is something directly below it as this can obstruct its view.
Mounting
Place the base plate at the desired location, ensuring that it is at least
20cm from the ceiling. Make sure the screw is facing up and the holes are
level. Use a pencil to mark the holes.
Using a 6mm drill bit, drill two 25mm deep holes over the pencil marks. For a
plaster, drywall, or concrete wall, insert the plastic anchors to support the
screws first.
Place the baseplate over the holes. Use the supplied screws to attach the baseplate to the wall.
Align the
large top screw with the largest hole on the snap mount. Slide the mount down
to lock into place.
Attach the
back of the camera to the mount. Adjust the angle as desired.
Device Information
Front
LED behavior
Device Information
Bottom
FAQ
What do I do if my device is not working properly?
Reset the device and reinstall it. To reset your device, press and hold the
Reset button until the LED starts to blink red.
During installation, ensure that:
• you have an Internet connection on your router
• your router’s Wi-Fi is enabled
• your mobile device is connected to the Internet
• your smart home hub is connected to the Internet
Why is there a white haze when viewing in night vision mode?
When viewing in night vision mode, the IR lights on your camera may be
reflecting off a nearby surface.
Try repositioning your camera to avoid glare from IR LEDs.
Support
For troubleshooting tips and more
information, visit: support.dlink.com
©2019 All rights reserved. D-Link and the D-Link logo are registered
trademarks of D-Link Corporation or its subsidiaries. Product
specification, size and shape are subject to change without notice,
and actual product appearance may differ from that depicted on the
package. Visit dlink.com for more details.
Version 1.00 (DI)_90X130
2019/07/04