XPS Sand Shark User Guide

June 7, 2024
XPS

XPS Sand Shark - logo Sand Shark
User Guide

Contents

  • RC Vehicle (Vehicle) x 1
  • RC Transmitter (Transmitter) x 1
  • Antenna for RC Transmitter x 1
  • Instruction Manual x 1
  • 6.4V Rechargeable Battery Pack x 1
  • Charger x 1
  • 9V Battery x 1
    XPS Sand Shark - Battery

Battery Precaution

  1. The 6.4V Lithium Rechargeable Battery Pack must be charged before use by utilizing the battery charger with included

  2. Do not overcharge the battery pack. Do not charge for more than 6 hours

  3. Do not charge the battery pack If It shows leakage, COMM Ion, or has loose or exposed wires

  4. Do not cover the battery pack with any sort of materials while charging

  5. Do not touch the battery pack when it is hot Wait until the battery peck cools before installing it in the Vehicle and before recharging

  6. Do not dispose of the battery In fire

  7. Do not dismantle the battery or charger, and do not cut the battery or charger cables

  8. The battery pack will be warm after charging, and hot after use in a vehicle

  9. The supply terminals are not be short-circuited

  10. Rechargeable batteries are to be removed from the toy before being charged

  11. Rechargeable batteries are only to be charged an adult.

  12. Battery replacement must be done by adults

  13. The transformer (charger) is not a toy

  14. Charge only type (1300rnAh Max) rechargeable battery packs.
    Other types of batteries may burst to cause Injury. This power unit Is Intended to be correctly orientated In a vertical or floor mount position. This charger Is intended to be used for charging a 6.4V Lithium rechargeable battery pack with a capacity 1300mAh Max It cannot be used for charging non- rechargeable batteries. Regular examination of battery charger for any damage to their cord,

  15. plug, enclosure, and other parts, and that, in the event of such damage, it must not be used with the charger or battery pack charge until such damage has been repaired. Note that the 9V battery is non-rechargeable and is not to be charged. Only batteries of the same or equhraktnt type as recommended are to be used. It will need replacement when the transmission is poor. Exhausted batteries are to be removed from the product.

Battery Installation

For Vehicle (Fig.1 end Fig2)

  1. Switch OFF the power
  2. Unscrew the screw on the battery cover.
  3. Open the battery cover.
  4. Install 6.4V battery pack Isvtth correct polarities (+1-) as shown inside the battery compartment.
  5. Close the battery cover.
  6. Tighten the screw on the battery cover.
    XPS Sand Shark - Battery instraction

Chomping the Rechargeable Battery Pack for the Vehicle:

  1. Conned thet3.4V lithium rechargeable battery pack to the battery charger
  2. Plug the charger into the standard AC socket
  3. The charging time for a full charge Is about 3 hours
  4. When charging Is completed, unplug the charger from the AC socket
  5. Disconnect the rechargeable battery pack from the battery charger
    Note: Red LED Indicates the battery Is charging. When LED turns green charging is complete.
    XPS Sand Shark - Battery instraction 2

For Transmitter (Flg.3 and Flg.4)

  1. Switch OFF the power.
  2. Unscrew the screw on the battery cover.
  3. Open the battery cover.
  4. Install 1 new 9V battery with correct polarity (+/-) as shown inside the battery compartment.
  5. Close the battery cover.
  6. Tighten the screw on the battery cover.

How to play

  1.  Switch ON the Vehicle and Transmitter.
    XPS Sand Shark - play

  2. Use the Steering Wheel to control the Vehicle turning left or right
    XPS Sand Shark - play 2

  3. Use the Accelerator Trigger to drive the Vehicle Forward, Stop and Backward
    XPS Sand Shark - play 3

  4. If the vehicle does not run in a straight line, adjust the Direction Adjustment on the Vehicle chassis (For example, if the vehicle steers to the right, adjust the direction switch to the left and vise versa.)

  5. Play on a smooth surface to have the optimum performance

  6. Remember to switch OFF the power of the vehicle and transmitter after playing

  7. The optimum control range is up to 13M / 40m outdoor Braking Action Keep driving forward rapidly then switch to backward for the braking action. When the trigger of the transmitter returns to the center position, push it again for the backward action.

Performance Tips

  1.  Do not drive on grass, dirt, sand, dust carpet, or go through water

  2. Do not drive in windy or rally weather

  3. Avoid direct Impact with obstacles

  4. Switch the power OFF when not in use to prevent damage due to battery leakage

  5. Remove all batteries from the Vehicle and Tramernftter when not In use for a long period

  6. Keep fingers, hair and lose chatting away from wheels

  7. The operating range can be affected by a variety of factors.
    a) Low Voltage of batteries tri Transmitter or Vehicle
    b) Interference from other linens that emit radio frequency signals

  8. Outdoor usage is recommended In order to get optimum control range

  9. Play with the vehicle on a dean, smooth surface

  10. Clean the battery compartment to make sure it is free from the duet to prevent poor battery contact

Cautions

  1. Do not attempt to disassemble the Vehicle or Transmitter
  2. Make sure the batteries are installed with correct polarities (+1-) as shown inside the battery compartment
  3. Remove the package and take out all accessories before giving the Vehicle and Transmitter to the child to play The packaging and Instruction manual contain Important Information. Please keep them for future reference.
    Warning! Choking Hazard. Not suitable for children under the age of 3 years due to small parts. We reserve the right to improve/amend specifications and colors without notice.

Cautions

  1. Do not attempt to disassemble the Vehide or Transmitter
  2. Do not operate the vehicle near the player(s) operating vehicles of the are frequency. This can cause interference and may cause the whi* to lose control.
  3. Make sure the batteries are installed with correct pointless (+0 ae shown inside the battery compartment.
  4. Remove the package end bare all accessories before giving the Vehicle and Transmitter to the child.

FCC label compliance statement,
This device complies with part 15 of the FCC rules. Operation is subject to the foaming two conditions:

  1.  This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may come umlauted operation.
    Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful Interference In a residential Installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used In accordance with the instructions, may cause harmful interference to radio communications. However, there Is no guarantee that interference will not max In a particular installation. If this equipment does cause harmful pertinence to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged ID try to correct the interference by one or more of the following measures:
    – Reorient or relocate the receiving antenna
    – Increase the separation between the equipment and receiver
    – Connect the ecp4rnent Into a cutlet on a drain different from that b which the receiver Is needed
    – Comsat the dealer or an experienced rediorTV technician for help
    Waning: Changes or modifications to this unit, not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

888-210 Compliance statement
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and medium (or lesser) gain approved for the transmitter by Industry Canada., To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotopically radiated power (e.i.r.p.) is not more than necessary for successful communication.
The device complies with Industry Canada licence-exempt RSS standard(s). Operation Is subject to the cause of interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Declaration of Conformity
The Product Is In conformity with the requirement of EU Directive 2014/53/EC

Environmental notes :
The whole product also does not belong to household waste at the end of the product life. You can return it at collection pont& for the recycling of electronic end electronic& instruments The ‘symbol on the Item, Instruction manual, hangtag or packing is showing this clearly, Materials should be recycled according to that respective markings. Recycling of old devices or another re-use of materials contained therein represents an important contribution to environmental p nitro Please ask at your local commonly for the correct collection point

Disposal of batteries
Batteries should not be disposed of In the household waste. As the consumer, you have legally obliged b return batteries containing harmful substances and ail other used batteries. You can hand in your old batteries et public collection paints in yam erne or wherever batteries are sold. YOU wit find these chemical abbreviations along with a crossed-out refuse bin on batteries courting harmful substances: Pb-Battery contains lead Cd=Bettery contains cadmium hisFISattery contains mercury

The pecilzgIng end Instruction manual contains important Information. Plane keep them for future reference. Warning! Choking Faccerd. Not suitable for children under the age of 3 years due to small parts. We reserve the right to improve the and specifications and colors without notice. Werningi The Antenna of a vehicle is not bi be inserted nits social outlets.

Frequency band 2405 – 2475 MHz Maximum Fiacio Frequency Power Transmitted: <0 dBm
FAST LANE IS A IAARK OF (EST UNE MARQUE DE/ ES UNA IMRCA DM GEOFFREY. LLC, A SUBSIDIARY OF (UNE RIAALE DE/UNA SUBSIDIARY\ DE) TOYS411″ US, INC. 2018 GEOFFREY, LLC MADE IN CHINA (FABRIOUEE EN CHINEITABRICADO EN CHINA) DISTRIBUTED IN THE UNITED STATES BY (DISTRIBUTE AUK ETATS•IAN’S PAR/DISTRIBUIDO EN LOS ESTADOS UNIDOS POW TOYSTUS. INC.. WAYNE. NJ 07470 IMPORTED BY (IMPORTED PARNMPORTADO BA) TOYSTUS (CANADA) LTD. (ITEM. 2777 U1KIGSTAFf RCM. CONCORD. ON L4K 4M5 DISTRIBUTED IN AUSTRALIA BY (DISTRIBUTE EN AUSTRALIE PAW DISTRIBUIDO EN AUSTRALIA PORI TOY$TrUS (AUSTRALIA (AUSTRALIE)) PTY 150.(ITEM). REGENTS PARK NSW 2143 www.loystus.com www.lownrsta.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals