tekstap SmartBright Solar WallLight User Guide
- June 7, 2024
- tekstap
Table of Contents
tekstap SmartBright Solar WallLight User Guide
Product Specification
Product Dimensions: 12 x 1.65 x 4.7 inches
Maximum Compatible Wattage: 11.1 Watts
Voltage: 3.7 Volts
Battery Parameter: 3.2V 4AH
Power Source: Battery Powered, Solar
Solar Panel: Polysilicon 5.5V, 2.5W,
Conversion Efficiency: 17%
Switch Installation Type: Screw
Luminous Flux: 2000 Lumen
Bulb Features: Waterproof, Motion-Sensor
Color Temperature: 6500 Kelvin
Average Life: 50000 Hours
Installation Instructions
| Size | W | L | H | WI | LI | HI | L2 | axb |
|---|---|---|---|---|---|---|---|---|
| Unit/MM | 305 | 119 | 42 | 286 | 42.4 | 2 | 160 | 16.5×4.8 |
- Turn on the wall light switch
- Drill two holes in the wall and put the collision column into the hole.
- Fix the product on the surface with screws.
Furcation Description
Intelligent Modes:
The LED Solar Lights have 3 Modes: Motion sensor mode, Dim light sensor
mode and Medium light stay-on mode, you can choose the mode according to your
diverse needs.
- Motion Sensor Mode: Solar lights charging during the day, auto turn on light at 100% brightness in darkness or at night when motion is detected and last about 15-30 seconds, then light will turn off totally when there is no motion.
- Dim light sensor mode: Solar lights charging during the day, auto turn on to continuous light at 5% brightness in darkness or at night when no motion is detected. It will turn to bright light at 100% when people motion is detected, then turn to dim light again at 5% when there is no motion after about 15-30 seconds.
- Medium light stay-on mode: Solar lights charging during the day, auto turn on to continuous light in darkness or at night at 20% brightness. The light will turn off after 6 hours.
Precautions
- During installation, please make sure that there is a reasonable angle between solar panel and ground. The installation angle can be adjusted according to the local latitude to ensure that the solar panel can receive as much sunlight as possible.
- There should not be any light source interference on the solar panel at night, otherwise fixture will not work normally at night.
- The battery will be low when the fixture is used for the first time. Please ensure that the fixture has sufficient sunlight to charge it after the installation. It should be charged more than 8 hours for the first time.
- This product is charged by solar panel, so it doesn’t need any other power supply.
- Auto run base on outside environment light intensity when at auto working mode.
- The use time will decrease when the operation temperature lower than 0 C.
- The light source of fixture isn’t replaceable, when the lamp reach it’s life limit, should replace the fixture.
- Battery inside the product is not replaceable.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>