De Longhi Oil Filled Radiator Instructions
- June 7, 2024
- De Longhi
Table of Contents
Instructions for use. Keep these instructions
Description
Important safeguards
INTRODUCTION
Thank you for choosing a De’Longhi product. Please take a few minutes to read
these instructions. This will avoid all risks and damage to the appliance.
IMPORTANT SAFEGUARDS
When using any electrical appliance, some basic safety precautions should
always be observed to reduce the risk of fire, electric shock, and/or injury
to persons. Specifically:
– Read all instructions carefully before using the appliance.
– If your radiator is equipped with polyethylene tape used as a carry handle,
remove it before connecting the appliance to the outlet.
– This appliance gets very hot when in use. To prevent burns, do not touch hot
surfaces with bare skin. use the handle when moving the appliance. Keep all
flammable materials, such as furniture, pillows, wedding, paper, clothing,
and curtains at least 3 feet (90 cm) from the front and top of the appliance,
also avoid contact with the sides and back.
– The appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children
should be supervised to ensure that they do not play with the appliance.
– Extreme caution is necessary when any heater is used by or near children or
invalids and whenever the heater is left operating and unattended.
– Always disconnect the plug from the power outlet when the appliance is not
in use.
– Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. If the heater has
leaked any oil, discontinue using the heater and contact the service center
as in- indicated in the instruction leaflet. Return heater to authorized
service facility for examination, electrical or mechanical adjustment, or
repair.
– Do not use the appliance outdoors.
– This heater is not intended for use in bathrooms, laundry areas, or similar
indoor locations. never position the appliance where it may fall into a
bathtub or come in contact with water.
– Do not run the power cord under carpeting. Do not cover cord with throw
rugs, runners, or the like. Keep the cord away from any passageways where it
could be tripped over.
– To completely turn off the appliance, push the On/Off button, and then
unplug the heater.
– Connect to properly polarized outlets only.
– Do not wrap the cord around the appliance immediately after use.
– Do not insert or allow foreign objects to get into the air intake or air
outlet grille, as this may cause electric shock or fire, or damage the
appliance.
– To prevent a possible fire, do not block air intake or air outlet grille in
any way. Do not use the appliance on soft surfaces, such as beds, here the
openings may become blocked.
– Do not cover the appliance while it is functioning in order to avoid
overheating and the risk of fire.
– The internal parts of the appliance can become very hot or produce sparks
during operation. Do not use the appliance in areas where gasoline, paints, or
other flammable liquids are used or stored.
– use this appliance only as described in this manual. Any other use not
indicated by the manufacturer may cause fire, electric shock, or injury to
persons.
– To prevent current overload and blown fuses, make sure that no other
appliance is plugged into the same outlet or into another outlet wired into
the same circuit.
– It is normal for the heater’s plug and cord to feel warm to the touch.
however, an excessively hot or deformed plug or cord is not normal and may be
the result of a defective electrical outlet. De- fective outlets must be
replaced before using the heater. Plugging the heater into a worn outlet may
result in overheating of the power cord or may cause the risk of fire.
– If the power cord is damaged, to reduce the risk of malfunction it must be
replaced by the manufacturer, its service agent, or a licensed and qualified
professional.
– Do not use this appliance with an extension cord or outlet strip. Connect
the appliance directly to a suitable outlet.
– Make sure that the plug is fully inserted into the outlet. Wall outlets may
deteriorate with time, so check the plug periodically for signs of overheating
or deformation. If the outlet has deteriorated, stop using it and have it
repaired.
– Check that neither the appliance nor the power cord has been damaged during
shipping.
– Make sure that no styrofoam or other packing materials remain in the
appliance.
– Make sure that no pieces of polystyrene or other packaging material have
been left between one element of the appliance and another. It may be
necessary to pass over the appliance with a vacuum cleaner.
– The first time the appliance is used, run it at the maximum power for at
least two hours. During this time, ventilate the room thoroughly to eliminate
the “new” smell released
by the appliance. It is completely normal for the appliance to emit
“creaking” sounds the first time it is run.
– CAuTIOn: To prevent electric shock, make sure the wide prong of the plug is
inserted in the wide slot of the outlet.
– Do not place the heater near a bed because objects such as pillows or
blankets can fall off the bed and be ignited by the heater.
– extreme caution is necessary whenever the heater is left operating
unattended.
– Do not open the appliance. no user-serviceable parts inside.
SAVE THESE INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE ONLY
DESCRIPTION
A
Display
B
On-off button
c
Power setting button
D
+ Adjustment button
E
– Adjustment button
F
Timer button
G
brightness button
H
eco button
I
Cord holder
L
Wheel
USE
“Easy wheel” system
Turn the radiator upside down on a rug or a soft surface in order to prevent
damaging the paint finish.
fully unfold the wheels by turning them outwards (fig. 1). Turn the radiator
back to its upright position.
Location
The heater must not be placed immediately below a power outlet. Do not use
this radiator in rooms having a surface area of less than 43 square feet (4
sq.m.).
Power connection
The radiator must be connected to a properly polarized A/C 110/120 V household
outlet in perfect working condition. The appliance will be set in the off
condition.
The display will show the symbol. Keep loose clothing or bedding, furniture
and flammable material away from the power outlet where the heater is plugged
in. After an interruption of the power supply (power failure or appliance
unplugged) the unit goes always to off.
When the unit is switched on by pressing the on-off button, the operating
conditions will be the same ones previously set.
Your product is equipped with a polarized alternating-current line plug (a
plug having one prong wider than the others). This plug will fit into the
power outlet only one way. his is a safety feature. If you are unable to
insert the plug fully into the outlet, try reversing the plug. If the plug
should still fail to fit, contact your electrician to replace your obsolete
outlet. Do not attempt to modify the plug to bypass this safety feature.
Heating function
To turn the appliance on, press the (b) button. Press button (C) to set the
required power level: MIn ( ); MeD ( ); MAX ( ).
To select the desired temperature, press button + or – (eor D). by pushing the
- or – button once, the temperature (shown on the display) will increase or decrease by 1°f or 1°C. holding the + or – button depressed the value will increase o decrease rapidly.
The appliance allows setting a temperature of 41°f (5°C) and a range from 50°f to 82°f (10°C to 28°C).
Anti-freeze function
Setting the temperature to 41°f (5°C), the appliance will activate the
Antifreeze function. The display will show the symbol, in this way the
appliance will turn on automatically, at the max power, only if the room
temperature falls below 41°f (5°C), to prevent freezing conditions. If you
wish to go back to the heating function, press the “+” button once.
note: in this function the power level settings are not able to be
adjusted, the unit will run at MAX.
Eco function
When this function is active the appliance automatically sets the most
appropriate power level to guarantee optimum comfort while reducing energy
consumption. To activate this function press the “ ECO ” (h) button. The
display will show symbols.
If the selected temperature is much higher than the actual room temperature,
the appliance will start automatically and rapidly to heat the room.
The appliance will automatically select the most convenient power level (
MAX-MED-MIn-oFF ).
If the MAX power level has been selected using the button, the appliance
will cycle between MAX-MED-MIN-OF F.
If MED power level has been selected, the appliance will cycle between
MED-MIN-0FF.
If MIn power level has been selected, the appliance will cycle
between MIN-OFF.
Working indicator
The symbol indicates the heating status by means of its colors.
RED: the unit is heating at maximum power.
YELLOW: the unit is heating at medium power.
GREEN: the unit is heating at the minimum power.
absent: the unit is not heating.
The brightness of the display
The appliance allows two different brightness settings for the display. The
highest is active when any key button is pressed. After a few seconds of
keyboard inactivity, the brightness will decrease to the operating brightness
level.
This lower level can be adjusted by means of the light button (G). Press the
light button repeatedly till the desired brightness is reached (three
brightness levels available).
Key lock
In order to avoid accidental operation, you can lock the keyboard using the
keylock function.
To activate this function press buttons + and – together for at least 3
seconds. The display shows the symbol and a double acoustic signal will be
emitted. To deactivate the function proceeds in the same way.
Timer function
This function can be activated in two different ways.
Delayed start: With the appliance off, press the timer button (f) .
The symbol is displayed flashing together with the hours left before the
appliance comes on. Change the hours using the + and – buttons, then wait a
few seconds for the program to be stored.
The display will return to off and the symbols remain on. When the programmed
time has elapsed, the appliance will come on with the previous settings.
Delayed stop: with the appliance on, press the timer button . The symbol
is displayed flashing together with the hours left before the appliance goes
off. Change the hours using the + and – buttons, then wait a few seconds for
the program to be stored. The current settings and symbols are displayed.
At the end of the set time, the appliance switches off automatically. To go
back to operating without the timer, press the timer button twice.
The timer symbol disappears from the display.
note: the time is settable from 0.5 to 24 hours.
change of the temperature scale
The display can show the temperature in both °f and °C. To select the desired
temperature scale, when the unit is in off position, press and hold the “+”
and “eCO” keys for at
At least 10 seconds, then release.
The change of scale will be indicated by two short beeps.
Alarms
The appliance has a diagnostic system that makes it possible to signal
malfunctions.
In case of problems, the display will show an alarm message:
(Probe failure)
With this alarm, the appliance does not operate. Contact the De’Longhi
Customer Service.
(high temperature)
When the product’s internal temperature is too high, the heating power will
progressively and automatically be reduced. The display shows intermittently
till the internal temperature is lowered. To remove the cause of this alarm
check that the unit is not covered or obstructed.
SAFETY DEVICE
A safety device switches the heater off in the event of overheating. Please call the De Longhi customer service.
MAINTENANCE
Always remove the plug from the power outlet and allow the radiator to cool.
Wipe the radiator with a soft damp cloth, do not use detergents and abrasives.
Should the radiator not be in use over a certain length of time, wind the cord
around the cord holder and store it in a dry place. This appliance has been
built to give many years f trouble-free service. In case of malfunction or
doubt, do not try to repair the heater by yourself: this may result in a fire
hazard or electric shock. Call the De’Longhi Customer Service.
TECHNICAL CHARACTERISTICS
Power supply
See rating plate
Absorbed power
TROUBLESHOOTING
PROBLEM | CAUSE | SOLUTION |
---|---|---|
The appliance doesn’t work The display shows: ht (high temperature) | – be sure |
it is plugged in and that the an electrical outlet is working.
– Check for any obstruction.
– The temperature may be set too low
– Probe failure, the display shows: Pf
– The unit is covered or obstructed.| – Plug into the power outlet.
– Remove the obstruction and let the appliance cool down. If the appliance
doesn’t work please contact the De’Longhi Customer Service.
– Set the temperature to a higher position.
– Contact the De’Longhi Customer Service.
– Check that the unit is not covered or obstructed. When the product’s
internal temperature decreases the alarm will disappear.
Limited warranty
This warranty applies to all products with De’Longhi or Kenwood brand
names.
What does the warranty cover?
We warrant each appliance to be free from defects in material and workmanship.
Our obligation under this warranty is limited to repair at our factory or
authorized service center of any defective parts or part thereof, other than
parts damaged in transit. In the event of a products replacement or return,
the unit must be returned transportation prepaid. The repaired or replacement
model will be returned at the company’s expense.
This warranty shall apply only if the appliance is used in accordance with the
factory directions, which accompany it, and on an alternating current ( AC )
circuit.
How long does the coverage last?
This warranty runs for one year (1) from the purchase date found on your
receipt and applies only to the original purchaser for use.
What is not covered by the warranty?
The warranty does not cover defects or damage of the appliance, which result
from repairs or alterations to the appliance outside our factory or authorized
service centers, nor shall it applies to any appliance, which has been subject
to abuse, misuse, negligence or accidents. Also, consequential and incidental
damage resulting from the use of this product r arising out of any breach of
contract or breach of this warranty are not recoverable under this warranty.
Some states do not allow the exclusion or limitation of incidental or
consequential damage, so the above limitation may not apply to you.
How do you get service?
If repairs become necessary, see contact information below:
u.S. Residents: Please contact our toll-free hotline at
1-800-322-3848 or log onto our website
at www.delonghi.com
Residents of Canada: Please contact our toll-free hotline at
1-888-335-6644 or log onto our website
at www.delonghi.com
Residents of Mexico: Please contact our toll-free number
01-800-711-8805 for assistance or log
onto our website at www.delonghi.com
The above warranty is in lieu of all other express warranties and
representations. All implied warranties are limited to the applicable warranty
period set forth above. This limitation does not apply if you enter into an
extended warranty with De’Longhi. Some states/countries do not allow
limitations on how long an implied warranty lasts, so the above exclusions may
not apply to you. De’Longhi does not authorize any other person or company to
assume for it any liability in connection with the sale or use of its
appliance.
How does country law apply?
This warranty gives you specific legal rights, and you may also have other
rights, which vary from state to state/country to country.
Visit www.delonghiregistration.com
to register your product online.
Visit www.delonghi.com for a list of service
centers near you.
References
- De'Longhi AU | De'Longhi Australia | Italian Home Appliances
- De'Longhi AU | De'Longhi Australia | Italian Home Appliances
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>