LIFESPAN KIDS Bentley Cubby House User Manual
- June 7, 2024
- LIFESPAN KIDS
Table of Contents
LIFESPAN KIDS Bentley Cubby House
GENERAL SAFETY INSTRUCTIONS
NOTE: This product is intended for outdoor domestic use only.
DANGER FOR CHILDREN
WARNING: No eating while using the product at the same time.
- Children do not recognize potential dangers from this product. The unassembled product must be stored out of reach of children and pets.
- This product may only be used with adult supervision at all times.
- The packaging material is not suitable for children due to choking and suffocation hazards.
RISK OF INJURIES
- Do not use the product if it is damaged or defective. If it is damaged or defective, please contact a qualified technician.
- Check the product before each use. Defective parts must be changed immediately as they can impair the function and the safety of the product.
- No more than one person to use the product at the same time.
- Use the product only on even and non-slipping surfaces. Never use it near water and keep sufficient space around for safety.
- Beware of moving parts such as the springs or elastics, which could catch your arms and legs. Do not place any objects or body parts in the product’s openings.
PRODUCT DAMAGE
Do not make alterations to the product. Only use original spare parts. Qualified technicians should only carry out repairs – improper repairs can lead to danger for the user. Use this product only as described in this manual.
ASSEMBLY ADVICE
-
The assembly of the product must be done carefully and by an able-bodied adult.
If in any doubt, ask a technically qualified person. -
Before you start with the assembly, read the instructions carefully.
-
Remove all packaging materials and lay down all parts on an open space.
This gives you an overview and simplifies the assembly procedure. -
Check with the parts list that all parts are available. Dispose of the packaging material when the assembly is completed.
-
Beware that when using tools or doing technical work, there is always a risk of injuries. Assemble the product with care.
-
Create a danger free environment; for example, do not let tools lay around the workspace. Store the packaging material in a way that cannot cause any danger.
-
After installing the product according to the instruction manual, ensure all screws, bolts and nuts are correctly installed and tightened and that all joints are secure.
-
Reasonable space must be kept between the product and possible sources of danger, such as other equipment swimming pools and fences.
-
The product must be assembled correctly before use.
-
Your play structure must be installed on a flat horizontal surface with a minimum of 2m between it and any structure or obstacle such as a fence, garage house, tree branches, cloths lines, or electric cables.
-
Modifications made to the original product shall be carried out according to the instructions of the manufacturer.
-
The product must always be used in a well-lit area.
-
Do not place anything under the product.
-
Use gloves during assembly and disassembly.
-
Outdoor products should be equipped with a device that in strong wind conditions avoid displacement due to wind (e.g. steel bars in the ground or loads like sandbag or water bags).
-
In certain areas during winter, snow buildup and the low temperatures can damage the product. It is recommended to remove snow buildup and to store the product indoor.
-
We strongly recommend visual inspections every 3 months to ensure the integrity of the entire product. Replace any parts as necessary.
SAFETY INSTRUCTIONS
- The safety instructions of the product should always be considered and obeyed.
- Using the product may result in permanent injury such as paralysis, or even death. Falling off the product may lead to injuries, particularly to the back, neck or head.
- No clothes with hooks or lose parts should be worn or carried during product usage in order to avoid hooks getting caught and causing injury.
- Strong winds can result in the product being blown away or damaged. If strong winds are predicted the product must be disassembled and moved to a sheltered area or sufficiently anchored down.
- Moving the product whilst assembled may affect the integrity of the frame. Should it be necessary to move the product, please consider the following:
- Force to be evenly spaced around the frame to lift the product off the ground.
- The product must be carried horizontally.
- Use caution whilst moving as it could bend the product frame.
- Users should be familiar with the assembly manual. This manual contains assembly guidance; selected precautionary measures as well as recommendations for servicing and maintenance of the product, in order to ensure a secured and fun use of the product.
- It is the responsibility of the owner or the supervisor to guarantee that all users of the product are informed sufficiently of all warning references and safety instructions.
FOR THE SUPERVISOR:
The supervisor’s role is to make sure users are aware of all safety
precautions and that these
precautions are enforced. When a supervisor is not available, the product may
be disassembled or
covered to limit access.
- The product can be only used if it is in good condition, worn or damaged parts should be replaced.
- Objects, which could be dangerous to the user, should be away from the product.
- Avoid unauthorized and unsupervised use of the product.
- Do not use the product under influence of alcohol or drugs (incl. medicines).
- Do not use the product as a jumping platform for other articles.
CONSUMER INFORMATION SHEET FOR PLAYGROUND SURFACING MATERIALS:
The US Consumer Product Safety Commission (CPSC) estimates that about 100 000
playground equipment-related injuries resulting from falls to the ground
surface are treated annually in US hospital emergency rooms. Injuries
involving this hazard pattern tend to be among the most serious of all
playground injuries, and have the potential to be fatal, particularly when the
injury is to the head. The surface under and around playground equipment can
be a major factor in determining the injury-causing potential of a fall. It is
self-evident that a fall on to a shock-absorbing surface is less likely to
cause a serious injury than a fall onto a hard surface. Playground equipment
should never be placed on hard surfaces, such as concrete or asphalt, and
while grass may appear to be acceptable, it may quickly turn to hard-packed
earth in areas of high traffic. Shredded bark mulch, wood chips, tine sand or
the gravel are considered to be acceptable shock absorbing surfaces when
installed and maintained at a sufficient depth under and around playground
equipment.
Table B.1 lists the maximum height from which a child would not be expected to
sustain a life-
threatening head injury in a fall on to four different loose-fill surfacing
materials if they are Installed and maintained at depths of 150 mm, 225 mm and
300 mm.
TABLE B.1: Fall height in millimetres from which a life-threatening head
injury would not be expected.
| 150mm| 225mm| 300mm
---|---|---|---
Double Shredded Bark Mulch| 1800| 3000| 3300
Wood Chips| 1800| 2100| 3600
Fine Sand| 1500| 1500| 2700
Fine Gravel| 1800| 2100| 3000
However, it should be recognised that all injuries due to falls cannot be
prevented, no matter what surfacing material is used.
It is recommended that a shock absorbing material extend a minimum of 1800mm
in all directions from the perimeter of stationary equipment such as climbing
frames and slides. However, because children may deliberately jump from a
moving swing, the shock absorbing material should extend in the front and rear
of a swing a minimum distance of twice the height of the pivot point measured
from a point directly beneath the pivot on the supporting structure.
This information is intended to assist in comparing the relative shock-
absorbing properties of various materials. No particular material is
recommended over another. However, each material is only effective when
properly maintained. Materials should be checked periodically and replenished
to maintain correct depth as determined necessary for the equipment in
question. The choice of a material depends on the type and height of the
playground equipment, the availability of the material in a particular area,
and its cost.
ASSEMBLY INSTRUCTIONS
CUBBY PARTS LIST
CUBBY SET UP
MAINTENANCE
WARNING: Please keep for future reference.
We recommend regular maintenance to be conducted at the beginning of each
season as well as at regular intervals during the usage session for your play
equipment to ensure all main parts/fixings are tightly secured, well-oiled and
intact to avoid failure, injury or hazards.
GENERAL ADVICE
It is of particular importance that this is followed at the beginning of each
season as well as at regular intervals during the usage season.
-
Check the accessories monthly as well as the play equipment’s structure to prevent falling risks.
-
Check and retighten screws, bolts, and all other hardware elements as necessary.
- Do not over tighten to avoid damaging the thread or cracking the surrounding wood.
-
Check all coverings and bolts for sharp edges and replace when required.
-
Lubricate all moving metallic parts.
-
When signs of oxidation and / or rust appear on various metallic parts of your equipment, sand rusted areas and tubular members and repaint using a non-lead-based paint
when required. -
Where applicable: check swing seats, chains, ropes, and other means of attachment for evidence of deterioration.
-
Replace when required in accordance with the owner’s manual.
If your play structure is disassembled, be sure to clearly mark any attached metal plates to prevent accidents. Check all bolt covers and sharp edges and replace them if necessary. For longer accessory life, we suggest storing them during the winter.
WOOD ADVICE
Our products are manufactured from premium timber. Great care is taking in selecting, machining, and treating the timber before it is sold to you.
- Inspect wood parts monthly. The grain of the wood sometimes will lift in dry periods causing splinters to appear. Light sanding may be necessary to maintain a safe environment. Treating your Product with protection (sealant) after sanding will help prevent severe checking/splitting and other weather damage.
- We have applied a waterborne translucent stain to your unit. This is done for colour only. Once or twice a year, depending on your climate conditions, you must apply some type of protection (sealant) to the wood of your unit. Prior to the application of sealant, lightly
sand any “rough” spots on your set. Please note this is a requirement of your warranty.
Bear in mind that timber is a natural product and may experience changes throughout the course of its life. It may:
- Develop openings/checks (gaps, slits, apertures, cracks) along the line of the grain.
- Fade as the timber reacts with sunlight.
All woods are hygroscopic, that is, it will absorb or discharge moisture to
attain equilibrium with the surrounding atmosphere. Timber openings/checks
occur due to the moisture content between internal
and outer surfaces of the timber. No two pieces of wood are exactly alike.
Each piece has its own characteristics and personality and reacts differently
to climate changes. When any wood products are exposed to the elements, it
develops ‘wood checks’. A check is the radial separation of the wood
fibres running with the grain of the wood. These are caused by the varying
temperature and moisture conditions. A check does not affect the strength or
durability of the wood or structural integrity of the play set.
WHEN SHOULD WOOD CRACKS BE A CONCERN?
Most of the wood splits will never become large enough to affect the
reliability and strength of our
products, however, there can be rare cases where splits can occur. This
happens when a crack develops past the halfway point from the timber,
splitting it into two separate pieces.
Feel free to contact us with detailed pictures of your product so we can
assess and ensure that your playground remains safe.
CLEANING
Do not use any abrasive cleansers for the cleaning. Use a soft, damp cloth to eliminate dirt and dust.
WARRANTY
AUSTRALIAN CONSUMER LAW
Many of our products come with a guarantee or warranty from the manufacturer.
In addition, they come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a
replacement or refund for a major failure and compensation for any other
reasonably foreseeable loss or damage.
You are entitled to have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not amount to a major failure.
Full details of your consumer rights may be found at
www.consumerlaw.gov.au.
Please visit our website to view our full warranty terms and conditions:
www.lifespankids.com.au/Warranty-Policy-Kids
WARRANTY AND SUPPORT
Please email us at
support@lifespankids.com.au for all
warranty or support issues.
For all warranty or support related enquiries, please lodge a support ticket
first by sending us an email.
support@lifespankids.com.au.
References
- Home | Consumer Law
- Lifespan Kids Official Store | Trampolines, Cubby Houses, Outdoor Play
- Warranty & Repairs – Lifespan Kids
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>