LIFESPAN KIDS SANDPITMIGHTY Mighty Sandpit Cover User Manual
- June 4, 2024
- LIFESPAN KIDS
Table of Contents
LIFESPAN KIDS SANDPITMIGHTY Mighty Sandpit Cover User Manual
WARNING: The disassembled product may contain small parts which pose a choking hazard to children under 3.
IMPORTANT:
This product may contain sharp points and small parts prior to assembly. The
owner’s manual contains safety, assembly, use and maintenance instructions.
This product must be assembled by an adult who has read and understood these
instructions. Keep the packaging away from children and dispose of all
packaging before use.
For the installer and your children’s safety, it is important to fully read and understand the instructions and safety hazards before commencing the assembly of the product.
NOTE:
This manual should not be used to guide your purchasing decision. Your
product, and the contents inside its carton, may vary from what is listed in
this manual. This manual may also be subject to updates or changes. Updated
manuals are available through our website at
www.lifespankids.com.au.
I. GENERAL SAFETY INSTRUCTIONS
NOTE: This product is intended for outdoor domestic use only.
1.1 DANGER FOR CHILDREN
WARNING: No eating while using the product at the same time.
-
Children do not recognize potential dangers from this product. The unassembled
product must be stored out of reach of children and pets. -
This product may only be used with adult supervision at all times.
-
The packaging material is not suitable for children due to choking and suffocation hazards.
1.2 RISK OF INJURIES
- Do not use the product if it is damaged or defective. If it is damaged or defective, please contact a qualified technician.
- Check the product before each use. Defective parts must be changed immediately as they can impair the function and the safety of the product.
- No more than one person to use the product at the same time.
- Use the product only on even and non-slipping surfaces. Never use it near water and keep sufficient space around for safety.
- Beware of moving parts such as the springs or elastics, which could catch your arms and legs. Do not place any objects or body parts in the product’s openings.
1.3 PRODUCT DAMAGE
- Do not make alterations to the product. Only use original spare parts. Qualified technicians should only carry out repairs – improper repairs can lead to danger for the user. Use this product only as described in this manual.
- Protect the product against splashes, humidity, high temperature and direct sunlight.
1.4 ASSEMBLY ADVICE
-
The assembly of the product must be done carefully and by an able-bodied adult. If in any doubt, ask a technically qualified person.
-
Before you start with the assembly, read the instructions carefully.
-
Remove all packaging materials and lay down all parts on an open space. This gives you an overview and simplifies the assembly procedure.
-
Check with the parts list that all parts are available. Dispose of the packaging material when the assembly is completed.
-
Beware that when using tools or doing technical work, there is always a risk of injuries. Assemble the product with care.
-
Create a danger free environment; for example, do not let tools lay around the workspace. Store the packaging material in a way that cannot cause any danger.
-
After installing the product according to the instruction manual, ensure all screws, bolts and nuts are correctly installed and tightened and that all joints are secure.
-
Reasonable space must be kept between the product and possible sources of danger, such as other equipment swimming pools and fences.
-
The product must be assembled correctly before use.
-
Your play structure must be installed on a flat horizontal surface with a minimum of 2m between it and any structure or obstacle such as a fence, garage house, tree branches, clothesline, or electric cables.
-
Modifications made to the original product shall be carried out according to the instructions of the manufacturer.
-
The product must always be used in a well-lit area.
-
Do not place anything under the product.
-
Use gloves during assembly and disassembly.
-
Outdoor products should be equipped with a device that in strong wind conditions avoid
displacement due to wind (e.g. steel bars in the ground or loads like sand bag or water bags). -
In certain areas during winter, snow buildup and the low temperatures can damage the
product. It is recommended to remove snow buildup and to store the product indoor. -
We strongly recommend visual inspections every 3 months to ensure the integrity of the entire product. Replace any parts as necessary.
II. SAFETY INSTRUCTIONS
-
The safety instructions of the product should always be considered and obeyed.
-
Using the product may result in permanent injury such as paralysis, or even death. Falling off the product may lead to injuries, particularly to the back, neck or head.
-
No clothes with hooks or lose parts should be worn or carried during product usage in order to avoid hooks getting caught and causing injury.
-
Strong winds can result in the product being blown away or damaged. If strong winds are
predicted the product must be disassembled and moved to a sheltered area or sufficiently
anchored down. -
Moving the product whilst assembled may affect the integrity of the frame. Should it be necessary to move the product, please consider the following:
1. Force to be evenly spaced around the frame to lift the product off the ground
2. The product must be carried horizontally
3. Use caution whilst moving as it could bend the product frame. -
Users should be familiar with the assembly manual. This manual contains assembly
guidance; selected precautionary measures as well as recommendations for servicing and
maintenance of the product, in order to ensure a secured and fun use of the product. -
It is the responsibility of the owner or the supervisor to guarantee that all users of the product are informed sufficiently of all warning references and safety instructions.
For the supervisor
The supervisor’s role is to make sure users are aware of all safety
precautions and that these
precautions are enforced. When a supervisor is not available, the product may
be disassembled or covered to limit access.
-
The product can be only used if it is in good condition, worn or damaged parts should
be replaced. -
Objects, which could be dangerous to the user, should be away from the product.
-
Avoid unauthorized and unsupervised use of the product.
-
Do not use the product under influence of alcohol or drugs (incl. medicines).
-
Do not use the product as a jumping platform for other articles.
Consumer Information Sheet for Playground Surfacing Materials
The US Consumer Product Safety Commission (CPSC) estimates that about 100 000
playground
equipment-related injuries resulting from falls to the ground surface are
treated annually in US
hospital emergency rooms. Injuries involving this hazard pattern tend to be
among the most serious of all playground injuries, and have the potential to
be fatal, particularly when the injury is to the head. The surface under and
around playground equipment can be a major factor in determining the injury-
causing potential of a fall. It is self-evident that a fall onto a shock-
absorbing surface is less likely to cause a serious injury than a fall onto a
hard surface. Playground equipment should never be placed on hard surfaces,
such as concrete or asphalt, and while grass may appear to be acceptable, it
may quickly turn to hard-packed earth in areas of high traffic. Shredded bark
mulch, wood chips, tine sand or the gravel are considered to be acceptable
shock absorbing surfaces when installed and maintained at a sufficient depth
under and around playground equipment.
Table B.1 lists the maximum height from which a child would not be expected to sustain a life threatening head injury in a fall on to four different loose- fill surfacing materials if they are Installed and maintained at depths of 150 mm, 225 mm and 300 mm.
TABLE B.1: Fall height in millimetres from which a life-threatening head injury would not be expected.
However, it should be recognised that all injuries due to falls cannot be prevented, no matter what surfacing material is used.
It is recommended that a shock absorbing material extend a minimum of 1800mm in all directions from the perimeter of stationary equipment such as climbing frames and slides. However, because children may deliberately jump from a moving swing, the shock absorbing material should extend in the front and rear of a swing a minimum distance of twice the height of the pivot point measured from a point directly beneath the pivot on the supporting structure.
This information is intended to assist in comparing the relative shock-
absorbing properties of
various materials. No particular material is recommended over another.
However, each material is only effective when properly maintained. Materials
should be checked periodically and replenished to maintain correct depth as
determined necessary for the equipment in question. The choice of a material
depends on the type and height of the playground equipment, the availability
of the material in a particular area, and its cost.
III. WOOD ADVICE
Our products are manufactured from premium timber. Great care is taken in selecting, machining, and treating the timber before it is sold to you.
- Inspect wood parts monthly. The grain of the wood sometimes will lift in dry periods causing splinters to appear. Light sanding may be necessary to maintain a safe environment. Treating your product with protection (sealant) after sanding will help prevent severe checking/splitting and other weather damage.
- We have applied a waterborne translucent stain to your unit. This is done for colour only. Once or twice a year, depending on your climate conditions, you must apply some type of protection (sealant) to the wood of your unit. Prior to the application of sealant, lightly sand any “rough” spots on your set. Please note this is a requirement of your warranty.
Bear in mind that timber is a natural product and may experience changes throughout the course of its life. It may:
- Develop opening/checks (splits, gaps, slits, apertures, cracks) along the line of the grain due to moisture & temperature changes.
- Colour fades as the timber reacts with sunlight.
MORE INFORMATION ON WOOD SPLITS
Each Lifespan Kids Timber Play Equipment is designed and built with tolerances
to account for wood splits. All timber components are dried, temperature
treated, and specified to the right size to ensure that the structural
integrity of your play equipment will not be compromised from normal
weathering. Most wood splits will never become large enough to affect the
reliability and strength of your play equipment.
Please note that in dryer seasons, wood splits will appear more often, and often in wet seasons, you’ll find that these wood splits will mostly disappear as the timber collects moisture and swells up. These are normal cycles
In the unlikely event you feel that a part has a possible fault in the timber, please contact Lifespan Kids immediately with pictures of the parts so they can be reviewed. Please refer to Page 15 to get in touch with us.
For more information: www.lifespankids.com.au/natural- timber
IV. ASSEMBLY INSTRUCTIONS
PARTS LIST
SET UP
V. MAINTENANCE
WARNING: Please keep for future reference.
We recommend regular maintenance to be conducted at the beginning of each season as well as at regular intervals during the usage session for your play equipment to ensure all main parts/fixings are tightly secured, well-oiled and intact to avoid failure, injury or hazards.
GENERAL ADVICE
It is of particular importance that this is followed at the beginning of each
season as well as at regular intervals during the usage season.
-
Check the accessories monthly as well as the play equipment’s structure to prevent falling risks.
-
Check and retighten screws, bolts, and all other hardware elements as necessary.
a. Do not over tighten to avoid damaging the thread or cracking the surrounding wood. -
Check all coverings and bolts for sharp edges and replace when required.
-
Lubricate all moving metallic parts.
-
When signs of oxidation and / or rust appear on various metallic parts of your equipment,
sand rusted areas and tubular members and repaint using a non-lead-based paint
when required. -
Where applicable: check swing seats, chains, ropes, and other means of attachment for
evidence of deterioration. -
Replace when required in accordance with the owner’s manual.
If your play structure is disassembled, be sure to clearly mark any attached metal plates to prevent accidents. Check all bolt covers and sharp edges and replace them if necessary.
For longer accessory life, we suggest storing them during the winter.
VI. CLEANING
Do not use any abrasive cleansers for the cleaning. Use a soft, damp cloth to eliminate dirt and dust.
VII. WARRANTY
AUSTRALIAN CONSUMER LAW
Many of our products come with a guarantee or warranty from the manufacturer.
In addition, they come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or refund for a
major failure and compensation for any other reasonably foreseeable loss or
damage.
You are entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. Full details of your consumer rights may be found at www.consumerlaw.gov.au.
Please visit our website to view our full warranty terms and conditions:
www.lifespankids.com.au/Warranty-Policy-Kids
WARRANTY AND SUPPORT
Any claim against this warranty must be made through your original place of
purchase. Proof of
purchase is required before a warranty claim may be processed. If you have
purchased this product from the Official Lifespan Kids website, please visit
www.lifespankids.com.au/warranty-form
For support outside of warranty, if you wish to purchase replacement parts or request a repair or service, please visit www.lifespankids.com.au/warranty- form and fill in our Repair/Service Request Form or Parts Purchase Form.
Read More About This Manual & Download PDF:
References
- Home | Consumer Law
- Lifespan Kids Official Store | Trampolines, Cubby Houses, Outdoor Play
- Warranty & Repairs – Lifespan Kids