Panasonic NN-TK714S Microwave Trim Kit Instruction Manual

Installation Instructions
Notice d’installation

Read carefully and keep these installation instructions.
© Panasonic Appliances Microwave Oven (Shanghai) Co., Ltd. 2014

Important Safety Instructions

CAUTION – Read and follow all instructions completely.

1. This Trim Kit is designed for use only with the Panasonic Microwave Oven listed in the table below, for installation into a cabinet.
2. The dimensions and ground clearance of the cabinet opening must be as indicated in Figure 1 on pages 6-8.
3. For safe use of your microwave oven, do not alter or modify any part of this kit or the microwave oven.
4. The microwave oven must be used with a properly grounded 3-prong receptacle in compliance with the National Electrical Code, as well as any applicable local regulations. Refer also to the microwave operating instructions for other safety and electrical requirements.
5. The microwave oven must be unplugged from the wall receptacle before attempting the installation of this kit.
6. Save these instructions for local inspection and relocation of the microwave oven.
7. Use caution so that the power cord is not pinched during installation.
8. The diagrams in these instructions may vary from the actual unit and is only for reference.
   Trim kit| Panasonic Microwave Oven Models
   ---|---
    NN-TK714S| NN-SE7S
   NN-SD7S
   NN-SN7S
   NN-ST7S

Parts List

Tools Needed: Measuring tape, pencil, Phillips screwdriver, Ø 2 mm ( 5/64″ ) drill

Parts Supplied

PART|

QUANTITY

| Trim Frame| 1
| Left Duct| 1
| Base Bracket Assembly| 1
| Bracket| 4
| Catch| 4
| Screw| 10
| Strike| 4

| Tape| 2

Installation Diagram

Trim Kit Dimensions

Width| 596 mm (23½”)
Height| 410 mm (16⅛”)
Depth (Thickness)| 20 mm (¾”)

Cabinet Diagram and Dimensions

|
---|---
|
|

Microwave Oven Preparation

|
---|---

Put a piece of the tape on the top of the oven and put a piece of the tape on the left of the oven and left duct.

Lower Duct Installation

Center Line of Cabinet

1. Aligning the base bracket assembly
   Position Base Bracket Assembly on a cabinet shelf. The front end of the Base Bracket Assembly should align flush with the front edge of the shelf.

2. Attaching the base bracket assembly

|
---|---

Cabinet Preparation

1. Attaching the bracket
   |
   ---|---
2. Bracket assembly

| 4 ×
4×

---|---

Press the left side first, and then press the right side.
( Note: Catch could be broken if over-pressing at the center area)

Trim Kit Preparation

Trim Frame

1. Inserting strikes

|
---|---

Microwave Oven Installation

Complete the assembly

1. Oven placement

|
---|---

Trim Kit/Finishing Installation

Complete the assembly

1. Trim frame installation

|
---|---

Note: Place the trim frame with the extended lip at the bottom

F0313BE94AP
PA0514-41117

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>