TUCKER Barbecue Dimensions Instructions
- June 3, 2024
- TUCKER
Table of Contents
TUCKER Barbecue Dimensions
Tucker Horizon BBQ is made for Outdoor Use Only!
Please Note: Dimensions to be used as a guide only. All Customers MUST refer
to the user manual supplied with the product for detailed installation
instructions. Please allow sufficient clearance for combustibles. Please do
not block any airways or vents. Sizes are correct at the time of printing.
Measurements are subject to change.
Tucker BBQs can not be held liable for changes to product sizes/ dimensions due to continual product upgrades. It is recommended you purchase your product prior to starting any building work involved with the installation of the product to make sure the sizes are correct.
Horizon with Roasting Hood Dimensions
Horizon with Flat Lid Dimensions
Horizon Built-in BBQ Cut-out Dimensions are Required when Built into Brickwork
Non-Combustible Material surround
Manifold Location on BBQ
The manifold is factory fitted at the back on the right-hand side. The
manifold diameter is 20mm square tube. The roasting hood is flush with the
back of the BBQ when open. The flat lid is 35mm high when shut and 510mm high
when open.
NOTE
Do Not place the gas cylinder underneath the barbecue, keep the required
clearance and ensure there is ‘permanent separation’, i.e. no line of sight
between the gas cylinder and the combustions area. If the gas cylinder is
enclosed, ensure adequate high and low ventilation (200 square cm each) as
required by AS/NZS 5601.1
Clearances Surrounding BBQ
The minimum clearances from a Horizon BBQ to combustible material
surrounding the BBQ are as follows:
- Above the BBQ: 800mm
- From the sides: 50mm
- From the rear: 100mm
Allow fresh air to circulate into the BBQ from underneath the BBQ. The minimum air ventilation required underneath is 200 square centimeters. For alternative types of installation, contact your nearest dealer.