TUCKER BARBECUES Gt5 Barbecue Built-In Dimensions User Manual
- June 7, 2024
- TUCKER BARBECUES
Table of Contents
TUCKER BARBECUES Gt5 Barbecue Built-In Dimensions
Minimum clearance to combustible material surrounding BBQ body below the
cooking surface is as follows:
200mm to the side walls.
200mm to the rear wall.
200mm to the bottom.
Minimum clearance to combustible wall surfaces above the cooking surface is
as follows:
100mm to the side walls.
100mm to the rear wall.
800mm above the cooking surface.
Tucker GT BBQs are for outdoor use only
Please Note: Dimensions to be used as a guide only. All customers MUST
refer to the user manual supplied with the product for detailed installation
instructions.
Please allow sufficient clearance to combustibles; Please do not block any airways or vents.
Sizes correct at time of printing. Measurements are subject to change. Tucker Barbecues is not liable for any changes to the sizes of BBQs.
The manifold diameter is a 20mm square tube. The manifold is factory fitted on the right-hand side of the barbecue at the front behind the fascia with a 3/8 SAE thread.
CUT-OUT DIMENSIONS FOR INSTALLATION OF A GT BBQ INTO A NON-COMBUSTIBLE MATERIAL SURROUND.
Documents / Resources
|
TUCKER BARBECUES Gt5 Barbecue Built-In
Dimensions
[pdf] User Manual
Gt5 Barbecue Built-In Dimensions
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>