Infinix X671B Note 12 Pro 5G User Manual

June 3, 2024
Infinix

Infinix LOGO 02 X671B
User Manual (B)

Explosion diagram specification

Infinix X671B Note 12 Pro 5G

1 CTP+LCM ASM 2 REC DECO ASM
3 F HSG ASM 4 FRONT CAM RUBBER
5 FRONT CAM 6 8W CAM FRAME
7 50M CAM FRAME 8 CAM 50M
9 MAIN PCBA 10 SIDEKEY FPC
11 CAM 2M 12 SPK
13 2M RUBBER 14 8W RUBBER
15 WATERPROOF FRAME 16 FM
17 HEAT DISSIPATION FILM 18 SIDEKEY
19 MID FRAME 20 MC SCREW L3.5
21 SIM CARD 22 CAM DECO FRAME
23 REAR FLASH HOOD 24 CAM DECO PART
25 LENS A 26 LENS B
27 BATTERY COVER 28 SPK RUBBER
29 DOWN SPK 30 CAM 8W
31 EARPHONE RUBBER 32 MOTOR
33 MAIN FPC 34 BATTERY
35 USB RUBBER 36 WHITE COAXIAL CABLE
37 BLACK COAXIAL CABLE 38 SUB PCBA
39 ANTENNA SPRING 40 SPK FRAME

Know your phone

Infinix X671B Note 12 Pro 5G - FIGURE 1

  1. Front camera
  2. Volume + key
  3. Volume – key
  4. Power key & side fingerprint sensor

SIM/SD card installation

  1. Power off mobile.
  2. Refer to the following picture for SIM / SD card installation.

Infinix X671B Note 12 Pro 5G - FIGURE 2

Charging the phone
You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone).
Use only INFINIX charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty.

Infinix X671B Note 12 Pro 5G - FIGURE 3

FCC Statement

  1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
  2. This device may not cause harmful interference.
  3. This device must accept any interference received, including interference that may cause undesired operation.
  4. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

SAR Information Statement
Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are conducted with the phone transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the phone while operating can be well below the maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output. Before a phone model is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the limit established by the government adopted requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for each model. The highest SAR value for this model phone when tested for use at the ear is 1.181W/Kg and when worn on the body, as described in this user guide, is 0.560W/Kg (Body-worn measurements differ among phone models, depending upon available accessories and FCC requirements). The maximum scaled SAR in hotspot mode is 0.783W/Kg. While there may be differences between the SAR levels of various phones and at various positions, they all meet the government requirement for safe exposure. The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RFexposure guidelines. SAR information on this model phone is on file with the FCC and can be found under the Display Grant section of http://www.fcc.gov/oet/fccid after searching on
FCC ID: 2AIZN-X671B Additional information on Specific Absorption Rates (SAR) can be found on the Cellular Telecommunications Industry Asso-ciation (CTIA) web-site at http://www.wow-com.com.
In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over one gram of tissue. The standard incorporates a sub- stantial margin of safety to give additional protection for the public and to account for any variations in measurements.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 10mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.
For DTS patents, see http://patents.dts.com. Manufactured under license from DTS Licensing Limited. DTS, the Symbol, & DTS and the Symbol together are registered trademarks or trademarks of DTS, Inc. in the United States and/or other countries. © DTS, Inc. All Rights Reserved.

Operating System :Android™
Android is a trademark of Google LLC.

Documents / Resources

| Infinix X671B Note 12 Pro 5G [pdf] User Manual
X671B, 2AIZN-X671B, X671B Note 12 Pro 5G, 2AIZNX671B, Note 12 Pro 5G, Note 12 Pro, 5G Note 12 Pro, 5G Smartphone, Smartphone
---|---

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals