TOPSTAR TSZ9A19-LD007 Self-Ballast LED Lamp Instructions
- June 6, 2024
- TOPSTAR
Table of Contents
TOPSTAR TSZ9A19-LD007 Self-Ballast LED Lamp
Product Features
- Compact structure and design – small, light weight, stylish
- Made with high quality parts and materials – high reliability
- Light-emitting elements and parts produced with new manufacturing technology – high lumen output
- The LED bulbs can’t be used in any dimmable circuit
Product drawing and dimensions
Model| Input| Power
(W)
| CCT （ K ）| Lamp
cap
---|---|---|---|---
TSZ9A19-LD007| 120VAC 50/60Hz| 9W| RGBCW| E26
Selection and installation instruction
- Open product packaging and check if product is intact, contact seller if found damaged.
- Check to confirm product rated voltage is same as local power grid voltage.
- Switch off light power.
- Hold bulb by plastic housing and install into light socket.
- Switch on/off as usual when power is connected.
Warning
- Do not put in dripping-wet environment.
- Do not touch bulb when switched on as high surface temperature may scorch and injure skin.
- Lumen output drops when bulb is used beyond rated lumen maintenance period. For better protection of your eyesight, do not use beyond rated period and replace bulb accordingly.
- Use in Damp Locations only
- This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC STATEMENT
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm
or more should be maintained between the antenna of this device and persons
during device operation.
To ensure compliance, operations at closer than this distance is not
recommended.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>