Swiss Madison® HD427WH Wall Hung Toilet Installation Instructions

@SwissMadison

WellMadeForever

www.swissmadison.com | 1-434-623-4766 | info@swissmadison.com

PRIOR TO INSTALLATION

• Inspect toilet to ensure no damages have occurred while in shipping.
• Observe all plumbing and building codes in accordance with your state and local requirements.
• All dimensions are nominal! Be sure to measure your toilet prior to installation.
• The step-by-step guidelines in the installation instructions are a general reference. Should there be any discrepancies, Swiss Madison cannot be held liable. It is recommended to install all Swiss Madison products by hiring a licensed professional.
• Read installation and maintenance instructions thoroughly before installing. Be sure to use proper tools and always wear proper personal safety accessories for your protection.
• Two people are recommended to handle and install this product as it is fragile.

If you have any questions or concerns please contact us:
1-434-623-4766
info@swissmadison.com

SUGGESTED TOOLS & MATERIALS

INCLUDED PARTS

1. Install Tank

   • Before toilet bowl installation, a wood frame and commercial or residential tank system is required.
   • Install according to manufactuer’s instructions.

2. Dry Fit Flange and Inlet Pipe

   • Fully insert straight tube into cistern flushing outlet then connect pipe into discharge outlet.
   • Draw lines to mark the finished wall location on each pipe as pictured below.
     

3. Determine Pipe Size

   • Apply lubricant on rubber washers of straight tube and connecting pipe, then insert into holes.
   • Draw lines on pipes as pictured below.
     

4. Cut Pipes

   • Using the marked lines, cut the straight tube and connecting pipe as instructed below.
   • After cutting, be sure to chamfer cut edges.
     

5. Mount Toilet Bowl

   • Apply lubricant to the joint surface on straight tube and connecting pipe.
   • Mount the toilet bowl to the wall.
     

6. Level and Attach Bowl

   • Attach bowl using the washers and bolts, make sure the bowl is level, then cover with included cap.
   • Fill any gaps with cement or sealant.
     

TOILET SEAT INSTALLATION

1. Disassemble

   • Disassemble the cover cap and the hinge.
     

2. Construct Hinges

   • Insert screw and nut into the hole on the hinge.
   • Attach blind hole screw fixing to the bottom of screw.
     

3. Attach Hinges

   • Insert hinges with blind hole screw fixings attached into holes on toilet bowl.
   • Lightly tighten hinges with a screwdriver too allow for later adjustment.
     

4. Adjust and Cover Hinges

   • Be sure the hinge is all the way forward for proper seat fitting.
   • Place the covers onto the hinges.
     

5. Adjust and Attach Seat

   • Align seat to the hinges then firmly tighten the hinges.
   • Attach seat to the secure hinges.
   • Adjust seat to align to the bowl.
     

TOILET SEAT USAGE

• To remove, push middle button until you hear a “click”, then pull straight up.
• To re-install, align hinge posts with reference marks on seat, then push down until your hear a “click”.

If you have any questions or concerns, please contact us directly at
1-434-MADISON (623-4766)

WARNING: Contents of your order may contain sharp and possibly other harmful pieces and may cause hazard to children and adults. Swiss Madison® is not responsible in any way for personal damages.

References

• Swiss Madison - Well Made Forever – Swiss Madison - well made forever

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>