resideo 390795 Remote Rod Adapter Installation Guide
- June 7, 2024
- resideo
Table of Contents
390795 Remote Rod Adapter for V800
Family of Combination Gas Controls
APPLICATION
The 390795 Remote Rod Adapter is for use in applications where a remote gas cock programming knob is needed. The remote rod adapter has a 5/16 in. sq. hole for a remote rod.
INSTALLATION
When Installing This Product…
- Read these instructions carefully. Failure to follow them could damage the product or cause a hazardous condition.
- The installer must be a trained, experienced service technician.
- After installation is complete, check out product operation as provided in these instructions.
CAUTION
Turn off gas supply before starting installation to prevent the dangerous
accumulation of fuel gases.
Install the remote red adapter as follows:
- The gas cock knob is retained by the square plastic cover shown in Fig. 1. Turn the knob to the PILOT position. Unscrew the two cover assembly screws and remove the cover.
- Liftoff and discard the original knob. Install new remote rod adapter on the valve shaft as shown in Fig. 1. The remote rod adapter can be fully seated in one position only. The cover cannot be reassembled unless the adapter and the valve shaft are properly oriented.
- Replace the plastic cover. Tighten screws evenly and securely.
Resideo Technologies, Inc.
1985 Douglas Drive North, Golden Valley, MN 55422
1-800-468-1502
60-0081—03 M.S. Rev. 05-20 | Printed in United States
www.resideo.com
© 2020 Resideo Technologies, Inc. All rights reserved.
This product is manufactured by Resideo Technologies, Inc. and its affiliates.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>