V-TAC AR111 LED Spotlight Instruction Manual
- June 7, 2024
- V TAC
Table of Contents
INSTALLATION
INSTRUCTION
AR111 LED SPOTLIGHT
WEEE Number: 80133970
TECHNICAL DATA:
Model| VT-1112|
VT-1112D
---|---|---
Watts| 12| 12
Base| GU10| GU10
Lumens| 900| 900
Beam Angle| 40°| 40°
CRI| >80| >80
PF| >0.9| >0.9
Dimmable| NO| YES
IP Rating| IP20| IP20
Body Type|
Plastic Clad Aluminum
Long Life| 20,000 Hours| 20,000 Hours
Rated Current| 0.05A| 0.05A
Dimension| Ø:11x86mm| Ø:11x86mm
Input Power| AC: 200-240, 50Hz| AC: 200-240, 50Hz
INTRODUCTION & WARRANTY
Thank you for selecting and buying the V-TAC product. V-TAC will serve you the
best. Please read these instructions carefully before starting the installing
and keep this manual handy for future reference. If you have any other
queries, please contact our dealer or local vendor from whom you have
purchased the product. They are trained and ready to serve you at your best.
The warranty is valid for 2 years from the date of purchase. The warranty does
not apply to damage caused by incorrect installation or abnormal wear and
tear. The company gives no warranty against damage to any surface due to
incorrect removal and installation of the product. The products are suitable
for 10-12 Hours of Daily operation. Usage of product for 24 hours a day would
void the warranty. This product is warranted for manufacturing defects only.
WARNING!
- Please make sure to turn off the power before starting the installation.
- Please connect directly to 220V
- Install only by certified Electrician. 4. The product uses a very high-power LED. As with any light source, direct viewing should be avoided. NOTE: Although easy to fit, this lamp requires wiring to the main and for safety should only be fitted by a qualified electrician.
This marking indicates that this product should not be disposed of with other
household wastes.
Caution, risk of electric shock.
NOTICE:
- Lighting installation should not be covered. Leave some space around the fixture for ventilation
- Risk of shock hence disconnects at fuse or circuit breaker before installation or servicing.
- Risk of fire, supply conductors (power wires) connecting fixture must be rated minimum 90°C. If uncertain, consult an electrician
INSTALLATION REQUIREMENT
- Please connect with the driver properly before connecting to the main supply.
- The lighting should be located in a dry area
INSTRUCTION INSTALLATION:
- Switch off the power before starting the installation.
- Push into the GU10 holder and rotate clockwise
- Turn on the power and test if installation is done properly without mistakes.
NOTE: For Dimmable models, make sure that the GU10 holder is properly
connected with the dimmer.
In case of any query/issue with the product, please reach out to us at:
support@v-tac.eu
For More products range, inquiry please contact our distributor or nearest
dealers.
V-TAC EUROPE LTD. Bulgaria, Plovdiv 4000, bul.
Karavelow 9B
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>