SECURITY-TRONIX SecurityTronix ThermScan ST-THERMSCAN-1 User Manual
- June 6, 2024
- SECURITY-TRONIX
Table of Contents
SecurityTronix ThermScan™
Wall Mounted Non-Contact Forehead Thermometer
ST-THERMSCAN-1
User Manual
This device is not intended to diagnose any medical condition but to raise
awareness if an elevated
skin temperature is detected.
securitytronix.com
nacebrands.com
Parts Included
- ThermScan Unit
- USB Cable
- USB Power Supply
- Screws (2)
- Anchors (2)
- Double-Sided Tape (4)
- User Manual and Specifications
Introduction
Specification
- Accuracy: ± 0.4°F (± 0.2°C), for greatest accuracy place it in the operating environment for 30 minutes before use. Requires a stable indoor climate-controlled environment.
- High- Temperature Alert: Flashing +”Di Di” sound. The preset alarm comes on at 99.1°F (37.3°C)
- Temperature Measurement Distance: 1.96 – 3.93″ (5 – 10 cm)
- Screen: Digital display
- Powering method: USB supplied power or battery (18650 Li-ion).
- Install method: Can be mounted with screws, double-sided tape (included), or on a tripod.
- Ambient Working Temperature: 50 – 104°F (10 – 40°C)
- Testing Temperature Range: 32 – 122°F (0-50°C)
- Temperature Measurement Speed: Less than 1 second
- Input: USB – DC 5V Power supply included
- Weight: 0.77lbs (350g)
- Dimensions: 6.69″ x 4.52″ x 5.51″ (170 x 115 x 140mm)
- Counting capacity: 999
Status Description
- Standby: The red dot at the bottom of the display lights up from left to right. (Fig. 1)
- Insufficient power: The horizontal bar lights up in the middle of the display. (Fig. 2)
- Normal temperature: Flashing green lights and alarm `Di’. (Fig. 3)
- Abnormal temperature: Flashing red lights and alarm `Di Di’ indicate this temperature. The preset alarm comes on at 99.1°F (37.3°C) (Fig. 4)
- Default: (bod: object mode)
Lo: Ultra-low temperature alarm. (Fig.5) HI: Ultra-high temperature alarm. (Fig. 6)
Operation Instructions
ST-THERMSCAN-1 | 07272020
-
Temperature measurement: Approach the nozzle until the thermometer registers a reading. Do not get so close that you touch the nozzle. Recommended distance: 2″ – 4″ (5 – 10 cm) (Fig. 7)
-
Mode switching: Settings can be changed using the small hole on the back of the device (Fig. 8). Insert a 3mm screwdriver, and briefly press the button to change between C° and F°. (Fig.9, 10) The unit consists of 3 “modes” of operation. To change the “mode” of the unit, hold the button for 3 seconds and release it.
A. BOD (BODY) – This mode is used when skin temperature is being read.
B. SUR (SURFACE) -This mode is used when the surface temperature is being read
C. COU (Counter) – This mode displays a digital counter. It is used to determine the number of readings the device has performed. *Does not display skin temperature when used in this mode. -
Install and replace the battery:
1 – Remove three screws
2 – Open the back base and install 18650 Li-battery -
Install methods:
1 – Screws (Included) mounting hole spacing – 130mm
2 – Double Sided Tape (Included)
3 – Tripod
The SecurityTronix ThermScan™ accurately and instantly scans the forehead and
alerts by alarm if an elevated skin temperature is detected. Quickly get
compliant with temperature screening at your place of business.
The intent is not to diagnose, but to raise awareness so people can get a
proper assessment before fully entering the business.
· Lower cost than thermal cameras
· Highly accurate
· Quick and easy to install
· Alarm function| · Contactless
· Reduces usage of PPE for manual scanning
· Quick automatic measurement
· Cost-effective, even for small businesses
---|---
Key Features
- Detects surface skin temperature without any contact
- Quickly detects surface temperature in less than one second response time
- Alarm alerts if the surface skin temperature detected is higher than 99.1°F (37.3°C)
- Digital display
Installation
- Can be mounted with screws (included), double-sided tape (included), or on a tripod
Specifications
Temperature Measurement Distance Temperature Measurement Accuracy| 2″ – 4″ (5
– 10 cm) ± 0.4°F (± 0.2°C)
---|---
Testing Temperature Range| 32 – 122°F (0-50°C)
Temperature Measurement Speed| Less than 1 second
Abnormal Temperature Alert| Yes
Working Voltage| USB – DC 5V Power supply included
External Power Supply| AC 100/60Hz
Power Consumption| Less than 3W
Operating Humidity| 95%, non-condensing
Working Temperature| 50 – 104°F (10 – 40°C)
Product Weight| 0.77Ibs (350g)
Product Dimension| 6.69″ x 4.52″ x 5.51″ (170 x 115 x 140mm)
Bracket| Wall Mount
Rating| FCC, RoHS, CE
ThermScan (ST-THERMSCAN-1)
This product is not a medical device, it is a non-medical surface temperature
thermometer.
It does not diagnose a medical condition.
ST-THERMSCAN-1 | 07272020
SecurityTronix ThermScanTM 1-Year Limited Warranty
SecurityTronix (the “Company”) warrants to the Original Purchaser that the ST-
THERMSCAN-1 Wall Mounted Non-Contact Forehead Thermometer purchased is free
from defects in workmanship or material under normal use. This warranty starts
on the date of shipment of the hardware to the Original Purchaser.
During the warranty period, the Company agrees to repair or replace, at its
sole option, without charge to Original Purchaser, any defective component. To
obtain service, the Original Purchaser must return the item to the Company
properly packaged for shipping. All defective products must be returned to the
Company within thirty (30) days of failure. Products must be returned with a
description of the failure and the Return Merchandise Authorization (RMA)
number supplied by the Company. To receive an RMA number and a return shipping
address on where to deliver the hardware, call
610-429-1821. The shipping and
insurance charges incurred in shipping to the Company will be paid by the
Original Purchaser, and all risk for the hardware shall remain with the
Original Purchaser until such time as the Company takes receipt of the
hardware. Upon receipt, the Company will promptly repair or replace the
defective unit, and then return said unit to Original Purchaser, shipping
prepaid. The Company may use reconditioned or like-new parts or units, at its
sole option, when repairing any hardware. Repaired products shall carry the
same amount of outstanding warranty as from the original purchase. Any claim
under the warranty must include dated proof of purchase or invoice. In any
event, the Company’s liability for defective hardware is limited to repairing
or replacing the hardware.
This warranty is contingent upon proper use of the hardware by Original
Purchaser and does not cover: if the damage is due to Acts of God (including
fire, flood, earthquake, storm, hurricane, or another natural disaster),
accident, unusual physical, electrical, or electromechanical stress,
modifications, neglect, misuse, operation with media not approved by the
Company, tampering with or altering of the hardware, riot, war, invasion, the
act of foreign enemies, hostilities (regardless of whether war is declared),
civil war, rebellion, revolution, insurrection, military or usurped power or
confiscation, terrorist activities, nationalization, government sanction,
blockage, embargo, labor dispute, strike, lockout or interruption or failure
of electricity, air conditioning, or humidity control, internet, network, or
telephone service.
The warranties given herein, together with any implied warranties covering the
hardware, including any warranties of merchantability or fitness for a
particular purpose, are limited in duration to one year from the date of
shipment to the Original Purchaser. Jurisdictions vary with regard to the
enforceability of warranty limitations, and you should check the laws of your
local jurisdiction to find out whether the above limitation applies to you.
The Company shall not be liable to your for loss of data, loss of profits,
lost savings, special, incidental, consequential, indirect, or other similar
damages arising from breach of warranty, breach of contract, negligence, or
other legal action even if the Company or its agent has been advised of the
possibility of such damages, or for any claim brought against your by another
party. Jurisdictions vary with regard to the enforceability of provisions
excluding or limiting liability for incidental or consequential damages. You
should check the laws of your local jurisdiction to find out whether the above
exclusion applies to you.
This warranty allocates risks of product failure between the Original
Purchaser and the Company. The Company’s hardware pricing reflects this
allocation of risk and the limitations of liability contained in this
warranty. The warranty set forth above is in lieu of all other express
warranties, whether oral or written. The agents, employees, distributors, and
dealers of the Company are not authorized to make modifications to this
warranty, or additional warranties binding on the Company. Accordingly,
additional statements such as dealer advertising or presentations, whether
oral or written, do not constitute warranties by the Company and should not be
relied upon.
This warranty gives you specific legal rights. You may also have other rights
which vary from one jurisdiction to another.
nacebrands.com|
securitytronix.com| 24/7/365 US-Based
Technical Support
610.429.0334
---|---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>