KLANG Dante 4 channel headphone amp User Guide

Quelle

4 channel headphone amp

MORE INFORMATION ONLINE:
www.kling.com/quelle

CONNECTIONS

1.  Connect external power supply if your network does not offer Power over Ethernet (PoE).
2. Connect CAT5e/CAT6 network cable to KLANG: Quelle and to your computer or Dante enabled product/network.

SOURCE

If you have another Dante-enabled product (e.g. mixing console) proceed with STEP 3. If not, follow the instructions below to enable your computer to stream audio via Dante.

1. OPEN www.KLANG.com/dante
2. Install Dante Virtual Soundcard (DVS) (free trial license available).
3. Start Dante Virtual Soundcard.
4. Set DVS as your output sound card. Play!

CONTROLLER

1. OPEN www.KLANG.com/dante
2. Install & Start Dante Controller (DC).
3. Turn off WiFi on your computer.
4. In DC, go to the ROUTING tab and double-click on your sound source. Go to the DEVICE CONFIG tab and choose the preferred sampling rate. Close this window.
5. Now, do the same for KLANG: Quelle and use the same sampling rate.
   Note : Dante devices can only be connected if they run at the same sampling rates! (Default: 48kHz)

ROUTING

Connect (stereo) audio stream from sound source to KLANG: Quelle Out Left and Right.

ENJOY LISTENING

Connect your headphones and adjust the GAIN Select switch: In-Ears: -12 or 0dB | Other: 0 or +12dB.

TECHNICAL DATA

WARNINGS AND PRECAUTIONS
Do not remove covers. Connect only to main sockets outlets with protective earth.
Do not handle power cords with wet hands. Do not expose to water or other types of liquids or moisture (rain, fog, dew, etc.).  Operating temperature: 0 °C to 50 °C (32 °F to 122 °F). Do not expose to heat sources.

COMPLIANCE
KLANG: Quelle has been tested and found to comply with the requirements defined in: EN55103-1:2009 EN 55103-2: 2009. EN 55022:2006 /CISPR 22:1997 CAN/CSA- CEI/IEC CISPR 22:02 FCC 47 CFR, Part 15.

SAFETY
EN 60065, 7th Edition, Rev.: 09/21/2012;
CAN/CSAC22.2 No. 60065:03 (R2012).
RoHS Compliant and Pb-Free.

WEEE – RECYCLING
According to RL2002/96/EG (WEEE – Directive on Waste Electrical and Electronic
Equipment) electronic equipment has to be recycled and does not belong to the standard waste. If you are unsure how to recycle this product please contact us and we will recycle the device for you.

DIMENSIONS
Weight: 2.9 kg | 6.4 lbs, Size (W/H/D): 44.5 / 4.5 / 18.5 cm
Front panel (width): 48.5cm | 19 inches
1 rack unit, gap between rack bolts (W/H): 46.5 / 3.5 cm.
WARRANTY – REGISTER ONLINE : www.KLANG.com/register

© KLANG:technologies GmbH, Aachen, Germany, 2019. All rights reserved.
No part of this document may be reproduced or transmitted in any form or by any means—electronic, mechanical, photocopy, recording, or otherwise—without written permission by KLANG: technologies GmbH |
Wespienstr. 8-10 | 52064 Aachen | Germany. +49 241 89 03 01 22 – support@KLANG.com – www.KLANG.com/quelle

References

• Dante | Getting Started - KLANG blog
• KLANG:quelle | Dante Breakout and Headphone Amp – Quick Start Guide
• Register - KLANG blog

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>