tc electronics SKYSURFER MINI REVERB User Guide
- June 6, 2024
- tc electronics
Table of Contents
tc electronics SKYSURFER MINI REVERB User Guide
Quick Start Guide
SKYSURFER MINI REVERB
Studio-Quality Reverb with 3 Award-Winning TC Electronic Algorithms in a Compact Footprint
- OUT – Send the signal to other pedals or a guitar amp via ¼” cable.
- 9 V DC – Connect a standard 9 V power supply (not included).
- IN – Connect your guitar via ¼” cable.
- REVERB – Adjusts the length of reverb decay.
- LED – Lights when the pedal is engaged.
- MIX – Adjusts the wet/dry mix such that turning clockwise results in more reverb.
- TYPE – Selects reverb model type – Spring, Plate or Hall.
- TONE – Adjusts the brightness of the reverb.
- FOOTSWITCH – Press to engage or bypass the pedal. True bypass leaves the guitar signal completely unaffected whenever the pedal is not engaged.
Specifications
FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION
TC Electronic
SKY SURFER MINI REVERB
Responsible Party Name: Music Tribe Commercial NV Inc.
Address: 901 Grier Drive
Las Vegas, NV 89118
USA
Phone Number: +1 747 237 5033
SKY SURFER MINI REVERB
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Important information:
Changes or modifications to the equipment not expressly approved by Music
Tribe can void the user’s authority to use the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>