KRONOX Black Motorcycle Fender Eliminator Installation Guide
- June 15, 2024
- KRONOX
Table of Contents
Black Motorcycle Fender Eliminator
Installation Guide
The box contains
Important!
This fender eliminator is a universal part that fits several motorcycle brands
and models.
Depending on your specific vehicle it might require particular modifications not
included in this instruction set. We recommend doing a brief online research
to understand how others have made similar modifications.
For your own safety, read and apply the recommendations contained at the end
of these instructions set.
Steps
Take off the original license
plate bracket and save the bolts. Remove the turn signals. Install the license
plate light.
Install the turn signals you
removed from your motorcycle in step 1.
Then install the license plate. If you wish, You can add the included
rejective or attach the license plate with them.
Install the fender eliminator on the motorcycle using the bolts you
saved in step
- Use the liberated screw holes from the original part.
Pass all the wires through the grommet. Connect the light cables and check
that the excess cable is collected under the seat. If you have doubts about
how to connect the patent light cable, check out this video. 
Adjust the distance, height, and angle of the bracket,
according to your motorcycle’s disposition. Make sure visibility is good and
all the screws are strongly adjusted to avoid any dangerous road situation.
Height-Adjustable 0mm to 38mm (1.49in) Extendable holder
Adjustable angle (45°)
Recommendations
Secure the screws using a thread-locking fluid. Fasten the cables of the lights
with security seals. This prevents possible breakage and annoying vibrations
Check frequently that the screws are still tight.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>