INSIGNIA 3 Key 2.4GHz Slim Wireless Mouse User Guide
- October 27, 2023
- Insignia
Table of Contents
INSIGNIA 3 Key 2.4GHz Slim Wireless Mouse
PACKAGE CONTENTS
- Wireless mouse
- USB nano receiver
- AA battery
- Quick Setup Guide
SYSTEM REQUIREMENTS
- Windows® 11, Windows® 10, macOS, and ChromeOS
- One available USB port
Before using your new product, please read these instructions to prevent any damage.
- Final flat size: 7.87 × 2.66 in. (200 × 67.5 mm)
- Final fold size: 1.96 × 2.65 in. (50 × 67.5 mm)
FEATURES
- 2.4GHz wireless connection eliminates cords
- Contoured design fits your left or right hand
- 3 DPI settings (800, 1,200, 1,600) adjust cursor speed
- Advanced optical tracking improves accuracy on most surfaces
SETTING UP YOUR MOUSE
- Pull the tab out.
- Pull off the cover, then remove the nano receiver.
- Insert the included AA battery into the battery compartment. Make sure that the + and – signs match the symbols in the compartment.
- Replace the battery cover.
Tip: Store the nano receiver in the mouse when it is not in use.
CONNECTING YOUR MOUSE TO YOUR COMPUTER
- Plug the nano receiver into a USB port on your computer.
- Slide the power switch on your mouse to ON. Your computer automatically detects your mouse and you can immediately begin using it.
ADJUSTING MOUSE SENSITIVITY
- Press the DPI button on the bottom of your mouse to cycle through three mouse sensitivity settings (800, 1200, and 1600).
- Wipe your mouse with a damp, lint-free cloth.
SPECIFICATIONS
- Dimensions (H×W×D): 1 × 2.4 × 4.3 in. (2.5 × 6.1 × 11 cm)
- Weight: 2.1 oz. (60 g)
- Battery: 1 AA alkaline battery
- Battery life: 3 months (based on average usage)
- Radiofrequency: 2.4GHz
- Operating distance: 33 ft. (10 meters)
- Electrical rating: 1.5V C.C. – 20mA
- DPI: 800/1,200/1,600 no receiver
- Dimensions (H×W×D): .18 x .52 x .76 in. (0.45 × 1.33 × 1.92 cm)
- Interface: USB 1.1, 2.0, 3.0
TROUBLESHOOTING
- Make sure that your mouse is turned on.
- Move your mouse closer to your computer.
- Make sure that your computer meets the system requirements.
- Only use your mouse on a clean, flat, non-slippery surface to ensure smooth and accurate cursor action.
- Check the battery in your mouse. The LED indicator blinks for 10 seconds when the battery is low.
- Avoid using your mouse on reflective, transparent, or metallic surfaces.
- Replace the mouse’s battery.
- Try connecting your nano receiver to a different USB port on your computer.
- Try moving other wireless devices away from the computer to prevent interference.
- Try restarting your computer with the nano receiver plugged in.
My mouse pointer or scroll wheel is too sensitive or not sensitive enough
- Press the DPI button on the bottom of your mouse to cycle through three mouse sensitivity settings (800, 1200, and 1600).
- Adjust the cursor or scroll wheel settings on your computer. Refer to the documentation that came with your computer.
LEGAL NOTICES
FCC Information
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Caution
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
RSS-Gen Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
RSS-102 Statement
This equipment complies with Innovation, Science and Economic Development
Canada’s radiation exposure limits set forth for an uncontrolled environment.
ONE-YEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA
For customer service, call 1-877-467-4289 (U.S. and
Canada)www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its affiliated companies. Distributed by Best Buy Purchasing, LLC7601 Penn Ave South, Richfield, MN 55423 U.S.A. ©2022 Best Buy. All rights reserved.