Xplova X2 Smart Cycling Computer User Guide
- June 6, 2024
- Xplova
Table of Contents
Xplova X2 Smart Cycling Computer User Guide
Package contents
- Xplova X2 Smart Cycling Computer
- Micro-USB Cable
- Bike Mount x1
- Rubber Pad x1
- Elastic Band x2
- Warranty Card
- Quick Start Guide
Getting to know your X2
A. POWER key:
Power on / Power off (Long press) Function setting: Save riding / Delete
riding
B. Lap / Back / Cancel
C. Confirm / Enter / Start / Pause
D. Next Page
E. Return to previous page
F. Micro-USB port
G. Bike mount latch
Installing your X2
Please follow the steps below to mount your X2 on the bike:
- Hold the bike mount on top of the rubber pad evenly together ensuring they are aligned squarely to each other. Then place them on the bike handlebar.
- Loop an elastic band from one tab of the bike mount. Stretch the free end of the elastic band underneath the bike handlebar and up to the other tab. Ensure the bike mount stays in place securely.
- Align the latch on the back of X2 with the bike mount notch. Press downward slightly and turn X2 until it locks in place.
Charging your X2
- Please use a standard Micro-USB charger with a 5V charging port. The battery will be fully charged within 2 hours.
- Please pull out the weather cap from the Micro- USB port with care to prevent breakage or deformation. Any damage to the weather cap may reduce its ability to resist dust and moisture.
Perform the initial setup
Press and hold the POWER key to power on X2 and follow the on-screen instructions to complete the initial setup step by step.
Screen overview
Basic settings
Riding mode
Status bar description
Status bar icon
Uploading activities
Using Xplova Connect App or USB to upload activities to websites and get more detailed analysis of your activities.
More exciting features
To maximize the functionalities of your X2, it is strongly recommended that
you install Xplova Connect App in your smartphone.
You can use Xplova Connect App to:
- View/store activities from X2
- Upload your activities/routes on different platforms (e.g., Xplova, Strava and others).
Open your smartphone’s application store (Google Play or App Store) and search for “Xplova Connect”, then download and install the application. To learn more about your X2, please download the User’s Manual at www.xplova.com.
Important safety instructions
The operating temperature of the device is between
- 10°C to 50°C.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Safety instructions
Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage points or other risks. Refer all servicing to qualified service personnel.
Unplug this product from the wall outlet and refer servicing to qualified service personnel when:
- The power cord or plug is damaged, cut or frayed.
- Liquid was spilled into the product.
- The product was exposed to rain or water.
- The product has been dropped or the case has been damaged.
- The product exhibits a distinct change in performance, indicating a need for service.
- The product does not operate normally after following the operating instructions.
- The product exhibits a distinct change in performance, indicating a need for service.
- The product does not operate normally after following the operating instructions.
- When unplugging the power cord, do not pull on the cord itself but pull on the plug.
- This product should be operated from the type of power indicated on the marking label.
Battery information
Batteries may explode if not handled properly. Do not disassemble or dispose of them in fire.
Do not tamper with batteries. Keep them away from children.
Follow local regulations when disposing of used batteries.
This device uses a Lithium battery. Do not use it in a humid, wet or corrosive environment.
Do not put, store or leave your product in or near a heat source, in a high temperature location, in strong direct sunlight, in a microwave oven or in a pressurized container, and do not expose it to temperatures over 50° C (122° F).
Failure to follow these guidelines may cause the battery to leak acid, become hot, explode or ignite and cause injury and/or damage. Do not pierce, open or disassemble the battery.
If the battery leaks and you come into contact with the leaked fluids, rinse thoroughly with water and seek medical attention immediately. For safety reasons, and to prolong the lifetime of the battery, charging will not occur at temperatures below 0 °C (32 °F) or above 40 °C (104 °F).
The full performance of a new battery is achieved only after two or three complete charge and discharge cycles. The battery can be charged and discharged hundreds of times, but it will eventually wear out. When the operation time becomes noticeably shorter than normal, buy a new battery. Use only the approved batteries, and recharge your battery only with the approved chargers designated for this device.
Never use any charger or battery that is damaged. Do not short-circuit the battery. Accidental short-circuiting can occur when a metallic object such as a coin, clip or pen causes direct connection of the positive (+) and negative (-) terminals of the battery. (These look like metal strips on the battery.)
Replacing the battery
Improper replacement or mishandling could damage the battery, cause Overheating, result in injury, or cause a risk of fire or explosion. Please check the user manual for the product information
Device with built-in Battery
Built-in battery must be replaced by an authorized service center. Do not
attempt to replace or remove the battery by yourself.
Disposal instructions
Do not throw this electronic device into the trash when discarding. To minimize pollution and ensure utmost protection of the global environment, please recycle. For more information on the Waste from Electrical and Electronics Equipment (WEEE) regulations, visit www.acer- group.com/public/Sustainability
European Union
This product must be used in strict accordance with the regulations and
constraints in the country of use. For further information, contact the local
office in the country of use. Please see https://europa.eu/european-union
/about-eu/countries_en for the latest country list. This equipment complies
with the essential requirements of the European Union directive 2014/53/EU.
See Statements of European Union Compliance, and more details refer to the attached Declaration of Conformity.
EU RF Radiation Exposure Statement: (SAR)
This device meets the EU requirements on the limitation of exposure of the general public to electromagnetic fields by way of health protection.
The limits are part of extensive recommendations for the protection of the general public. These recommendations have been developed and checked by independent scientific organizations through regular and thorough evaluations of scientific studies. The unit of measurement for the European Council’s recommended limit for mobile devices is the “Specific Absorption Rate” (SAR), and the SAR limit is 2.0 W/kg averaged over 10 grams of body tissue. It meets the requirements of the International Commission on Non-Ionizing Radiation Protection (ICNIRP).
For body worn operation, this device has been tested and meets the ICNIRP exposure guidelines and the European Standard, for use with dedicated accessories. Use of other accessories which contain metals may not ensure compliance with ICNIRP exposure guidelines.
Read More About This Manual & Download PDF:
References
- Acer Laptops, Desktops, Chromebooks, Monitors & Projectors | Acer United States
- xplova
- European Union | European Union
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>