SUPERIOR ELECTRONIC NAO-001 High Gain Antenna Instruction Manual
- June 6, 2024
- SUPERIOR ELECTRONIC
Table of Contents
NAO-001 AMPLIFIED
OUTDOOR ANTENNA
HIGH GAIN ANTENNA
ANTENNA DIGITALE AMPLIFICATA PER ESTERNI
Instruction Manual
PACKAGE CONTENTS:
A 1x HD/Full HD/Ultra HD DVB-T2 Antenna
B 1x Antenna power adapter (5 V, 500 mAC 1x Instruction manual
D 2x Wall plugs
E 2x Self-tapping screw
F 1x Double-sided tape
Before using this antenna, please, read the instruction manual carefully.
TECHNICAL DATA:
HD (720p), Full HD (1080i, 1080p),Ultra HD (4K/2160p)
Range of frequencies: VHF: 170-230 MHz; UHF:470-694 MHz
Gain: 25 dB (Max)
Cable connector: F-type, male
Cable length: 5.0 m + 1.0 m (USB cable of power adapter)
Impedance: 75 Ω
Voltage (USB adapter): 5 V, 500 mA
Operating temperature: -20~85 °C
Operating humidity: 20~80%
Dimensions: (8.9 x 24.8 x 6.0) cm
INSTALLING THE ANTENNA
A OUTDOORS
1. The distance between the two marks must be 48 mm| 2. Use a 5 mm-
diameter drill bit for the holes
---|---
| 
3. Drill holes Wall plugs Self-tapping screws| 4. Wall
| 
B INDOORS
| Clean the surface chosen for the installation of the antenna
carefully
---|---
| Make sure that the two-sided adhesive tape adheres perfectly to
the surface
| Remove the protective film
| Press the antenna on the tape, holding it down for at least 30
seconds
CONNECTION OPTIONS
With power adapter and receiver/decoder
|
With power adapter only
---|---
Direct
Advice for best reception:
– The antenna is designed to be installed either indoors or outdoors.
– Not all digital signals are high definition. Make sure that the digital
receiver supports the definition of the channels you wish to view.
– Make sure that the antenna and the power adapter are properly installed.
The antenna power adapter has a USB cable that must be connected to an active
USB port (5 V, 500 mA).
The signal light goes on to show that it is operating properly.
– It is recommended that the antenna be installed high up (on a wall, for
example), preferably close to a window and away from obstacles such as trees,
buildings, etc.
– If signal reception is not good enough, try changing the direction of the
antenna, scanning the channels once again.
(A)
– If the image is not clear, try connecting the antenna directly to the
receiving device (TV, decoder, etc.), without connecting the USB power
adapter.
– It is best to scan the channels periodically, to make sure that all the
services offered are available.
NOTE: The quality of the signal and the number of channels received can
depend on a number of factors, such as the distance of the TV from the
transmission source, the power of the signal, metal constructions in the
vicinity, and other environmental considerations.
SIMPLIFIED EU DECLARATION OF CONFORMITY –
Hereby, Superior Srl declares that the radio equipment type active outdoor
antenna “NAO-001” is in compliance with Directive 2014/53/EU, Directive
2011/65/EU, Directive
(EU) 2015/863. The full text of the EU declaration of conformity is available
at the following internet address:https://www.superior-
electronics.com/dl/Certifications/NAO001_CE-DoC.pdf
Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>