SPL LED CORD DIMMER Installation Guide
- June 6, 2024
- spl
Table of Contents
SPL LED CORD DIMMER Installation Guide
Cord Dimmer Snoerdimmer Kabeldimmer
Installation instructions
- Make sure that there is no voltage on the cord to be connected when mounting!
- Open the housing by loosening and removing the screws C
- Remove button A and cover B
- Loosen the screws of the strain relief D
- Clear the wire ends (approx. 5 mm)
- Connect the veins of the feeding cord (where the plug is attached) to points L and N
- Connect the cord to the lamp to OUT connections on the circuit board
- Secure the cord with the strain relief D
- Replace housing B and button A
- Fasten the housing using the screws C
Load type / Soort belasting Art der Belastung| 0-50W LED 10-100W Halogen /
Incandescent
---|---
Dimming method / Dim methode Dimmmethode| R,C Trailing Edge / Fase afsnijding
Fase abschnitt
Dimming style / Dim manier / Art des Dimmen| Rotary / Draaiknop / Drehknopf
Memory function / Geheugen functie peicherfunktion| Yes / Ja
Ambient temperature / Omgevings temperatuur Umgebungstemperatur| Max. 35° C
Dimensions / Afmetingen / Abmessungen| 30.4 x 24.9 x 96.8 mm
Gewicht / Weight| 36.9 g
Schiefer Lighting Pottenbakkerstraat 35 4871 EP Etten-Leur NL www.spl- lighting.com
Set minimum and maximum brightness
- Turn on the lights by pressing the button and turn the knob to the minimum brightness
- Insert the screwdriver into the MIN screw and turn it to the left
- If the light becomes unstable (flashes), turn the screwdriver to the right until the blinking stops
- Now turn the knob to maximum brightness and insert the screwdriver into the MAX screw and turn it to the right
- If the light becomes unstable (flashes), turn the screwdriver to the left until the blinking stops
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>