Kmart Clip On Metal Shade Pendant Instruction Manual
- June 6, 2024
- Kmart
Table of Contents
CLIP ON METAL SHADE PENDANT
Item no.: 2104-13A
Keycode: 42963691
INSTRUCTIONS FOR INSTALLATION:
Caution: Before adding or replacing your pendant, make sure the electricity is switched off and any plugs are removed from the wall socket. Always allow bulb to cool completely before installation. Caution: Always ensure pendant is completely installed and secure before connecting to an electricity supply.
-
Remove Metal Shade Pendant.
-
If you are using an E27 Edison Screw Bulb, remove Part (A) from the shade as per diagram.
If you are using an E14 Edison Screw Bulb, please skip this step and move on to Step 3. -
Ensure Part (B) and Part (C) are secured together as per diagram.
-
Install Metal Shade Pendant to light fitting.
-
Install Globe (not included) into the Lamp Holder.
-
Check to ensure that all the components have been assembled correctly.
-
Connect to electricity to see Metal Shade Pendant light up.
(A)
Plastic Adaptor only to be used for E14 Edison Screw Bulb. See Step 2.
Remove plastic adaptor:
- Hold the plastic adaptor.
- Pull the plastic adaptor out from open gap. (C)
Care information
- Carefully read all instructions for the assembly and use of this product before connecting to an electricity supply.
- Light bulbs become very hot in seconds. Do not attempt to touch the light while the lamp is lit and supervise others accordingly.
- Before cleaning or replacing shade, switch off the light and unplug from the mains socket. Allow the bulb to cool for at least 10 minutes before touching it and making the change.
- Ensure the new bulb is secure in the lamp holder before reconnecting to the power supply. If in doubt, consult a qualified electrician.
FOR INDOOR USE ONLY.
Documents / Resources
|
Kmart Clip On Metal Shade
Pendant
[pdf] Instruction Manual
Kmart, Clip, On, Metal, Shade, Pendant
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>