V-TAC VT-629 29W LED Panel Instruction Manual
- June 6, 2024
- V TAC
Table of Contents
WEEE NUMBER: 80133970
INSTALLATION INSTRUCTION
TECHNICAL DATA:
| Model | VT-629 |
|---|---|
| Shape | Square |
| Watts | 29W |
| Lumens | 3480LM |
| beam angle | 120° |
| CRI | >80 |
| Pr | >0.9 |
| IP Rating | IP20 |
| On/Off Cycle | >20,000 |
| Long Life | 30,000 Hours |
| Operation Temperature | -20°C to +40°C |
| Input Power | AC:200-240V-, 50/60Hz |
INTRODUCTION & WARRANTY
Thank you for selecting and buying the V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installing and keep this manual handy for future reference. If you have any other queries, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at your best. The warranty is valid for 5 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 Hours of Daily operation. Usage of product for 24 hours a day would void the warranty. This product is warranted for manufacturing defects only.
WARNING!
- Please make sure to turn off the power before starting the installation.
- The light source of this luminaire is not replaceable, when the light source reaches its end of life the whole luminaire should be replaced.
- If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
- Install only by certified Electrician.
- For Indoor use only
This marking indicates that this product should not be disposed of with other
household wastes.
Caution, risk of electric shock.
Luminaires are not suitable for covering with thermally insulating material.
Note: The panel works on DC 30-42V, please connect correctly with the conductor before connecting the conductor to the power supply main.
INSTALLATION DIAGRAM:
- Make a hole into the ceiling.
- Fix the panel into the ceiling.
- Wire the DC cable of the panel to the driver and then wire the AC source cable to the power supply.
- Turn on the switch, test the fixture light on.
IN CASE OF ANY QUERY/ISSUE WITH THE PRODUCT, PLEASE REACH OUT TO US AT:
SUPPORT@V-TAC.EU
FOR MORE PRODUCTS RANGE, INQUIRY PLEASE CONTACT OUR DISTRIBUTOR OR NEAREST
DEALERS. V-TAC EUROPE LTD. BULGARIA, PLOVDIV 4000, BUL.L.KARAVELOW 9B