KUFATEC 33985 Audi A4 8K TV in Motion Instruction Manual

KUFATEC 33985 Audi A4 8K TV in Motion

General advice

Congratulations to your new TV in motion interface. Thank you for choosing a product of Kufatec GmbH.

• While developing this product, your personal safety combined with the best operating service, modern design and an up-to-date production technique was especially taken into account.
• Unfortunately, despite the utmost care injuries and/or damages might occur due to improper installation and/or use.
• Please read the attached instruction manual completely with great care and keep it!
• All articles of our production line pass through a 100 % check – for your safety and security.
• We reserve the right to carry out technical changes which serve the improvement at any time.
• According to each article and purpose, it is sometimes necessary to check each country’s legal regulations before installing and starting the unit.
• In case of guarantee claims, the device has to be sent back to the seller in the original packaging with the attached bill of purchase and detailed defect‘s description. Please pay attention to the manufacturer‘s return requirements (RMA). The legal warranty directions are valid.
• The guarantee claim as well as the operating permission becomes invalid due to:
  • unauthorized changes to the device or accessories which have not been approved or carried out by the manufacturer or its partners
  • opening the device‘s frame
  • device‘s repairs carried out by one‘s own
  • improper use/operation
  • brute force to the device (drop, wilful damage, accident etc.)

During installation, please pay attention to all safety-relevant and legal directions.
The device has only to be installed by trained personnel or similarly qualified people.

Safety Instructions

Installation requires special knowledge.
Do not install the unit yourself. For safe and reliable installation, consult a dealer having special knowledge.

• Never use bolts or nuts from the car’s safety devices for installation. If bolts or nuts from the steering wheel, brakes or other safety devices are used for installation of the unit, it may cause an accident.
• Use the unit with a DC 12V negative ground car. This unit cannot be used in large trucks which use a DC 24V battery. If it is used with a DC 24V battery, it may cause a fire or accident.
• Avoid installing the unit in the following places:
  • Where it would hinder your safe driving.
  • Where it could damage the car’s fittings.
• This unit is only for use in the following vehicles. Only connections described within this instruction guide are allowed or required to use for installation.
• For damage impact caused by faulty installation, unsuitable connections inappropriate vehicles Kufatec GmbH assumes no liability.
• We advise you that these units process datas out of the CAN – protocol from the vehicle. As the supplier of this device we don‘t know the overall system you are working with. If our device causes damage due to other changes made by to the vehicle Kufatec GmbH assumes no liability.
• Kufatec GmbH suppliers do not guarantee the use of the product for changing within a new vehicle series.
• If the car manufacturers don‘t agree with the installation of our device by reason of warranty Kufatec GmbH assumes no liability. Please check conditions and warranty before you begin the installation.
• Kufatec GmbH supplier reserves the right to change the device specifications without notice.

ATTENTION: In most countries, it is forbidden to watch TV while driving. We are not liable for any damages caused through this procedure. The TV/ DVD in motion option should only be used for the other passengers of the car and not by the driver.

References of legal regulations for operation
Only use this unit in the intended domain.
If you use it in a foreign domain, if the unit is not installed properly, or if the unit will be reconstructed, the guarantee will expire.

TV/Video in motion

MMI 2G

• Specific module to use the TV source of the MMI 2G while driving
• Easy processing of activation as well as deactivation – Plug & Play

MMI 3G

• Specific module to use the DVD/ TV source of the MMI 3G while driving
• Playing of DVD‘s by using the 3G main unit possible
• Easy processing of activation – Plug & Play

Scope of delivery

• Interface

Diagnostic Interface

NOTE: The coding dongle is just suitable for one vehicle.

Please make sure the infotainment MMI 3G did boot up completely.
!!! Wait another 2 minutes !!!
Now you can complete the TV in motion activation!

Once the activation for an MMI 3G infotainment system has been completed a deactivation is not possible again (only possible for MMI 2G).

Regarding article-ID 36942 (not 33985) an integrated LED (from hardware 2.0) light will show the current status of the diagnostic interface (table below). – NO LED FUNCTIONALITY IN CASE OF MMI 2G

Coding

1. Turn on the ignition, wait another 30 seconds, and put the interface into your car‘s OBD connection. The OBD-Box is located in the driverside‘s footwell close to the upper cover (image 2).
2. Once the coding has started the LED will give a constant light. As soon as the coding has finished the LED will turn off. The interface can be disconnected.
   Depending on the vehicle the coding can take up to a minute.

NOTE: During the coding (LED constantly on) the interface must not be disconnected! In case the LED is still on after 3 minutes the interface can be disconnected.

again

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>