SONY MDR-XB55AP Extra Bass In Ear Headphone Instruction Manual
- June 6, 2024
- Sony
Table of Contents
SONY MDR-XB55AP Extra Bass In Ear Headphone
Notice for customers: the following information is only applicable to products
sold in countries applying EU directives and/or UK applying relevant statutory
requirements.
This product has been manufactured by or on behalf of Sony Corporation. EU and
UK Importer: Sony Europe B.V.
Inquiries to the EU Importer or related to product compliance in Europe should
be sent to the manufacturer’s authorized representative, Sony Belgium,
bijkantoor van Sony Europe B.V., Da Vincilaan 7-D1, 1930 Zaventem, Belgium.
Inquiries to the UK Importer or related to product compliance in the UK should
be sent to the manufacturer’s authorized representative, Sony Europe B.V., The
Heights, Brooklands, Weybridge, Surrey KT13 0XW, United Kingdom.
Disposal of old electrical & electronic equipment (applicable in the European
Union and other countries with separate collection systems)
This symbol on the product or on its packaging indicates that this product
shall not be treated as household waste. Instead it shall be handed over to
the appropriate collection point for the recycling of electrical and
electronic equipment. By ensuring that this product is disposed of correctly,
you will help to prevent potential negative consequences for the environment
and human health, which could be caused by inappropriate waste handling of
this product. The recycling of materials will help to conserve natural
resources. For more detailed information about recycling of this product,
please contact your local Civic Office, your household waste disposal service
or the shop where you purchased the product.
A: How to use
- Multi-function button
- Microphone
**B: Earbuds
** Compatible products
Use this unit with smartphones.
Notes
- If you connect to an unsupported smartphone, the microphone of this unit may not function, or the volume level may be low.
- This unit is not guaranteed to operate digital music players.
*Using the Multi-function button1**
Press once to answer the call, press again to end; press to play/pause a
track.
Available operations for iPhone
Plays/pauses a track of the connected iPhone product with a single press.
Skips to the next track with a double press. Skips to the previous track with
a triple press. Starts the “Siri*2” feature with a long press (if available).
Hold down for about two seconds to reject an incoming call. When you let go,
two low beeps confirm the call was rejected.
1 The button function may vary depending on the smartphone.
2 Availability of the “Siri” feature depends on iPhone and its software version.
Specifications
Headphones
Type: Closed, dynamic
Driver unit: 12 mm, dome type (CCAW Voice Coil)
Power handling capacity: 100 mW (IEC*)
Impedance: 40 Ω at 1 kHz
Sensitivity: 106 dB/mW
Frequency response: 4 Hz – 24,000 Hz
Cable: Approx. 1.2 m, Litz wire, Y-type
Plug: L-shaped gold-plated 4-pole mini plug
Mass: Approx. 8 g without cable
Microphone
Type: Electret condenser
Directivity: Omni directional
Open circuit voltage level: –40 dB (0 dB = 1 V/Pa)
Effective frequency range: 20 Hz – 20,000 Hz
Supplied accessories
Hybrid silicone rubber earbuds: SS (1 line) (2), S (2 lines) (2), M (3 lines)
(attached to the unit at the factory) (2), L (4 lines) (2) / Carrying pouch
(1)
- IEC = International Electrotechnical Commission
Design and specifications are subject to change without notice.
iPhone and Siri are trademarks of Apple Inc., registered in the U.S. and other
countries.
Replacement parts: Hybrid silicone rubber earbuds
Please consult your nearest Sony dealer for information about replacement
parts.
Removing the headphones
After use, remove the headphones slowly.
Note: Headphones are designed to fit closely in your ears. If the
headphones are pressed hard while in use or taken off too quickly, they may
cause injury. Wearing headphones may produce a diaphragm click sound. This is
not a malfunction.
Precautions
High volume may adversely affect your hearing.
Do not use the unit while walking, driving, or cycling. Doing so may cause
traffic accidents.
Do not use in hazardous areas unless the surrounding sound can be heard.
If the earbuds are not securely attached, they may fall off and remain inside
the ear during use. Make sure that the earbuds are securely attached before
use.
There is a danger that small parts may be swallowed. After use, store in a
location out of reach of small children.
Note about static electricity
If you use the unit when the air is dry, you may experience discomfort due to
static electricity accumulated on your body. This is not a malfunction of the
unit. You can reduce the effect by wearing clothes made of natural materials
that do not easily generate static electricity.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>