aiwa AT-X80FANC Active Noise Cancelling TWS Buds User Manual

AT-X80FANC Active Noise Cancelling TWS Buds
User Manual

Unboxing

Please refrain from using any damaged components. Contact your local authorized AIWA distributor/customer service.

product Overview

Product Usage Guide

POWER ON: (Automatic): Remove earbuds from charging case.
Indicator lights should light up and Rash briefly.
CONNECTING MOBILE DEVICE TO EARBUDS:
Select “AT-X80 FANC” from your mobile device’s Bluetooth menu.
Voice prompt: Your device is connected” indicates a successful connection.
SHUT DOWN : (Automatic): Place earbuds back Into the charging case.
Note Earbuds will power down automatically after 5 minutes of inactivity/ disconnection.
• Please charge earbuds before using them.

MANUAL POWER OFF

Long press L and R earbuds for ten (10) seconds until red indicator lights flash thrice.

MANUAL POWER ON

Long press L and R earbuds for three (3) seconds until white indicator lights flash thrice.

ENTER PAIRING MODE

After resetting the earbuds, (refer to page: “Reset my earbuds”), short press both earbuds for three (3) seconds until indicator lights turn on. The Earbuds are now available to pair with your mobile device.

Tap Control Guide

•ANC ON/ ANC OFF/ APT ON: Operates in a cycle.

Reset my earbuds

Disconnect earbuds from all mobile devices.
Manually power off earbuds (Long press L and R earbuds for ten (10) seconds until the red indicator light Rashes thrice).

Long press both earbuds for ten (10) seconds until BOTH RED & WHITE indicator lights light up at the same time thrice.
Place both earbuds back into the charging case within five (5) seconds. You can now proceed to remove the earbuds and connect them to your mobile device.
After Resetting, delete -AT-XSOFANC” from your device’s ST lid.

Important Safety Instructions

1. Please do not use devices near any form of heat source.
2. Please use accessories specified by the manufacturer.
3. Please refer all servicing to qualified personnel should there be any form of damage to the device.
4. Keep this user manual for future reference/ troubleshooting
5. Please heed ALL safety cautions

Safety cautions

1. Keep device AWAY from fire and heat sources at all times.
2. Do not attempt to disassemble or alter the device.
3. Do not expose the device to excessive heat.
4. Do not immerse/ expose the device to any form of fluids.

Warning

Using earphones at moderate to high volumes for extended periods of time will result in permanent hearing damage. We recommend that you keep the media playback volume level from low to moderate at all times.
Please do not use earphones while performing activities that require hearing surrounding noises/ sounds. (Driving, Cycling, jogging, etc.)

Battery

AT-X80 FANC provides up to four (4) hours of playback time & additional. twelve (12) hours from the charging case.
Upon closing the charging case cover;
– Indicator light up RED: Low battery
– Indicator light lights up GREEN: Battery Fully Charged
“AT–X80 FANC powers off automatically after 5 minutes of inactivity/disconnection

Charging

Use USB Type-C charging cable to charge.
Recommended Charging voltage: 5V500mA to 1A
AT-X80 FANC powers off automatically after 5 minutes of inactivity/disconnection.
Battery will be discharged automatically if left unused over a long period of time.

List of Voice Prompts

Power ON
Pairing
Your device is connected
Your device is disconnected Batten/ Low
Power OFF
Min.& Max. Volume Alarm
Reject or End Call Alarm

• Only certain anchored phones are supported
• IOS phones rill not support this feast

Reset Success Alarm
ANC ON
ANC OFF
APT ON (Transparency mode ON)
Gaming Mode ON*
Gaming Mode OFF

Gaming Mode Designed fa garners: Enables honer ST latency. This might lower audio quality.

Indicator Lights Guide

(Earbuds Indicator Lights)
Performing manual Power ON: Flashes in WHITE X3
Performing manual Power OFF: Flashes in RED x3
Performing manual Pairing: Alternating RED & WHITE
Standby: Flashes in WHITE every five (5) seconds. Indicator Lights Extinguished
During Music Playback: Alternating RED & WHITE lights X3
Successful Earbuds Reset Alternating RED & WHITE lights X3 Alternating RED & WHITE Lights on WHITE every five (5) seconds on another earbud.
Upon BT Disconnection (Entering Pairing Mode): Alternating RED & WHITE Lights on either earbud, WHITE every five (5) seconds on another earbud.
Removing Earbuds from Charging Case (Entering Pairing Mode): Flashes in WHITE
Incoming Call:
(Charging Case Light) Battery Level (<20%): Flashing RED
Battery Level (20% – 95%): Flashing GREEN
Battery Level (>95%): Solid Green
While Charging the Charging case, Battery Level (<20%): Flashing RED
Battery Level (20% – 95%): Flashing GREEN
Fully Charged: Solid Green

Cleaning & maintenance

Troubleshooting

I can’t find” AT-X80FANC” on my Bluetooth device’s list/ unstable connection

1. Make sure “AT-X80FANC” and your device are within Bluetooth working distance.
2. Make sure “AT-X80FANC” is charged and has enough power.
3. Perform a factory reset and re-attempt to pair again.

Disconnection occurred within Bluetooth working distance.

1. Please make sure there are no metals or other materials within a relatively close range which will interfere with the Bluetooth connection.

The tap controls don’t seem to be working.

1. Check if the earbuds are connected to your Bluetooth device. Recommended devices operating system – 10S 8,0/ Android 4.3 and above.
2. Tap sensors are only activated 1 second after a successful connection to avoid misoperation.

Customer service

For more product information please visit www.int-aiwa.com Contact your local authorized dealer/ customer service. Refer to the warranty label provided in the box.

Data Sheet

Earphone Type: Active Noise Cancelling TWS
Bluetooth Version: Bluetooth V5.0
Bluetooth Chipset: RTL8773, Supporting BDR/EDR, BLE
Bluetooth Profile: HFP, HSP, A2DP, AVRCP
Wireless Range: 10 meters (Free Space)
Audio Decode: SBC AAC
Speaker diameter : Φ10mm ± 0.2mm
Speaker impedance: 32ohms ±15%, at 1KHz, Input: 0.126 VRms
Speaker Rated Power: 3mW
Frequency Response: 50Hz to 20KHz
Sensitivity : 98±3dB at 1KHz, Input 2.5mW
Max. SPL : z 104dB
Noise reduction : 23-25dB
Halt Sensor : Hall Sensor x 1
Battery: Earbuds : 40mAh Li Polymer
Battery: Charging Case : 500mAh Li Polymer
Music Playback Hours: ANC ON 4H + 12H Charging Case
Input Voltage & Current : DC3.7V 0)500mA to 1A (Charging Case)
Charging Port : Type C
Charging Hours : Earbuds 1H,Charging Case 1H
Earbuds Dimension : 22.8x20x36.5 mm
Charging Case Dimension : 45.5x57x23 mm
N.W. : 60g ( 2 x5g earbuds, 50g charging case )
*Design and specifications are subject to changes without prior notice.

Aiwa Electronics Intl Co., Ltd.
Explore more at www.int-aiwa.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>