Russell Hobbs 25070-70 Electric Kettle Instructions
- June 6, 2024
- Russell Hobbs
Table of Contents
Russell Hobbs 25070-70 Electric Kettle Instructions
Read the instructions, keep them safe, pass them on if you pass the appliance on. Remove all packaging before use.
IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience
and knowledge if they have been supervised/instructed and understand the
hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be done by children unless they are
older than 8 and supervised.
Keep the appliance and cable out of reach of children under 8 years. Parts of
the appliance will get hot during use. If you overfill, the kettle may spit
boiling water. Use the kettle only with the stand supplied (and vice versa).
If the cable is damaged, it must be replaced by the manufacturer, its service
agent, or someone similarly qualified, to avoid hazard. Avoid spillage on the
stand/connector. The surface of the heating element is subject to residual
heat after use.
Use the appliance according to these instructions. Any misuse may cause potential injury, electric shock or other hazards. This appliance is intended to be used in household and similar applications such as:
- staff kitchen areas in shops, offices and other working environments;
- by clients in hotels, motels and other residential type environments;
- bed and breakfast type environments;
- farm houses.
- Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
- Don’t use the kettle for any purpose other than heating water.
- Don’t operate the appliance if it’s damaged or malfunctions.
PARTS
- Filter
- Lid lock
- Lid
- Water level gauge
- Switch
- Stand
BEFORE USING FOR THE FIRST TIME
Fill to max , boil, discard the water, then rinse. Do this twice to remove any manufacturing dust, etc.
FILLING
- Open the lid.
- Fill with at least 1 cup of water, but not above max.
- Close the lid, and press down to lock it.
USING YOUR KETTLE
- Put the stand on a stable, level surface.
- Plug the stand into the wall socket.
- Put the kettle on the stand.
- Move the switch to I.
- The light will come on. The kettle will start to heat.
- When the water boils the kettle will switch off.
- To switch off manually, move the switch to O, or simply lift the kettle off the stand.
GENERAL
Note: When you lift your kettle, you may see moisture on the stand. This is normal and is caused by the steam used to switch your kettle off automatically.
BOIL DRY PROTECTION
If your kettle boils dry, a safety cut-out device will automatically switch it off. If this happens, unplug your kettle and allow it to cool down until the cut-out resets itself. Allowing your kettle to boil dry will shorten the life of the element.
CARE AND MAINTENANCE
- Unplug the stand, and let the kettle cool before cleaning.
- Wipe all surfaces with a clean damp cloth.
- Open the lid.
- Push the hook on top of the filter down then lift the filter out of the kettle.
- Rinse the filter under a running tap while brushing with a soft brush.
- Lower the filter into the kettle, and engage the bottom hook in the bottom of the spout.
- Press the top of the filter towards the kettle, to lock the hook in place.
- Close the lid.
Descale regularly, (at least monthly).
Use a proprietary descale. Follow the instructions accompanying the descale.
Products returned under guarantee with faults due to scale will be subject to
a repair charge.
RECYCLING
To avoid environmental and health problems due to hazardous substances, appliances and rechargeable and non-rechargeable batteries marked with one of these symbols must not be disposed of with unsorted municipal waste. Always dispose of electrical and electronic products and, where applicable, rechargeable and non-rechargeable batteries, at an appropriate official recycling/collection point.