ALPINE Map and Navi Firmware Update Procedure Instructions

June 6, 2024
Alpine

ALPINE logo

INE-F904DC / X903DC / X803DC / INE-W720DC Series map 2020/12 and Navi firmware update procedure

Map and Navi Firmware Update Procedure

Please check the Audio Firmware Version on your device first. If your Audio Firmware Version is NOT 1.4001.1.4001.1.4001 or higher, please update your Audio Firmware before. Check Audio “Firmware Version” in Setup: General About Firmware Version. The map 2020/12 and Navi firmware can be updated with only one USB device. First, please download the “2020-12_camperMAP.zip” and follow the instructions. The INE-F904DC / X903DC / X803DC / INE-W720DC can be updated via USB connection (see connection diagram below). Before starting the update, please check the following notes. The download file is compressed in zip format. The contents of the download need to be extracted to a freshly formatted USB device (FAT32). The update takes 40 to 50 minutes.
Update file contents/storage place (for all types of units)

ALPINE Map and Navi Firmware Update

Notes

  • Do NOT use the compressed file for updates, otherwise, the Unit cannot recognize the files.
  • Do NOT change folder names and file names, otherwise, the Unit cannot recognize the files.
  • Do NOT store the folder inside another folder.
  • Do NOT store any other folders files on the USB device.
  • Do NOT remove the USB device while
  • Do NOT update while
  • Do NOT press any buttons while updating.
  • Do NOT turn off the vehicle’s ignition or head unit’s power switch while updating.

Modem vehicles will shut down the ignition (ACC) after some time if the engine is not running. If you are not sure if this applies to your car, leave the engine idling while the update is in progress.

Connection

ALPINE Map and Navi Firmware Update-Connection

Install Navi firmware and map update

  1. Store the downloaded and extracted files -2020-12_camperMap2Ip” on the empty USB device in the Root Folder (see left figure).
  2. Connect the USB device to the USB connector of the Alpine Head Unit. Please see the lower left figure.ALPINE Map and Navi Firmware Update-Unit
  3. Press the “OK” button when an update message appears on the screen. The process will now install the new map data to your Alpine Head Unit.ALPINE Map and Navi Firmware Update-Update
  4. The new map data and navigation application is loaded successfully when your Alpine Head Unit restarts automatically.ALPINE Map and Navi Firmware Update-Map data
  5. Remove the USB device from Alpine Head Unit.ALPINE Map and Navi Firmware Update-Head
  6. Check the “Nay! Firmware” version by pushing Navigation: 4 Information 4 About 4 Version Information. The new Navi Firmware version is 9.35.2.259310, Jun 22, 2021
  7. Check “Map-Version” by pushing Navigation: 4 Information 4 About 4 Content 4 Maps. If ‘Map-Version” has changed to: “… 2020.12”, this map update procedure has been successful.

ALPS ALPINE Europe GmbH, Alpine Brand

Documents / Resources

| ALPINE Map and Navi Firmware Update Procedure [pdf] Instructions
ALPINE, INE-F904DC, X903DC, X803DC, INE-W720DC Series, Map, and, Navi, Firmware, Update, Procedure
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals