BRIGHT TANGERINE B4002.1021 Metabones RF-to-PL Lens Adapter Installation Guide
- June 6, 2024
- BRIGHT TANGERINE
Table of Contents
BRIGHT TANGERINE B4002.1021 Metabones RF-to-PL Lens Adapter
INSTALLATION GUIDE
B4002.1021 – RED KOMODO METABONES RF-PL SUPPORT
The RF mount on the Komodo is a sprung mount system, and relies on small
springs inside the mount to pull the adapter into the right place.
If the adapter support is installed incorrectly, it can result in the lens
adapter being pushed or tilted in the wrong direction, which can result in
focus and other optical issues.
The following installation sequence must be followed in order to ensure that
the adapter is supported correctly on the camera body.
You will need to use a 2.5mm Hex Key.
Step 1 – Prepare the RED Komodo with the required plates. Ensure all the
plates are secured and tight.
Step 2 – Using a 2.5mm Hex key, mount the support to the camera using the
four screws (A) but do not tighten fully at this point.
Step 3 – Install the lens adapter into the camera, allowing it to twist
onto the camera body and click into place.
Step 4 – Using the 2.5mm Hex key, gently tighten the clamping screw (B)
on the support so that it starts to hold onto the adapter.
Step 5 – Tighten up the mounting screws (A) on the side & top plate in a
criss-cross pattern.
Step 6 – Fully tighten the clamp screw (B) on the adapter support.
Step 7 – To remove the support. First, loosen the clamp screw (B) before
loosening the mounting screws (A) on the side & top plate.
For further assistance, contact the support team at
support@brighttangerine.com
DOCUMENT DATE: 05/27/21
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>