Russell Hobbs RHPH2001 500W Plug In Heater Instruction Manual

Plug-In Heater

Model Number: RHPH2001
220-240V AC 50Hz 500W
This product is only suitable for well-insulated spaces or occasional use
For Customer Services please call 0345 209 7461
Or visit us at mda.russellhobbs.com

PLEASE RETAIN FOR FUTURE REFERENCE

SAFETY INSTRUCTIONS

When using electrical appliances, basic safety precautions should always be observed, including the following:

• Read all instructions.

• Check that your mains voltage corresponds with the rating on the appliance.

• This appliance must be positioned upright on the floor away from curtains, furniture or wall coverings, and other flammable items.

• The appliance must not be left unattended while it is connected to the main supply.

• Do not touch hot surfaces. Use the handle or the controls.

• To protect against electrical shock do not immerse the cord, plug, or appliance in water or other liquid. Do not operate with wet hands.

• Do not let the cord hang over the edge of a worktop, table, etc., or touch hot surfaces.

• Do not operate any appliance with a damaged cord or plug, or after the appliance malfunctions or is dropped or damaged in any manner. The supply cord cannot be replaced. If the cord is damaged the appliance should be scrapped.

• The use of accessory attachments not recommended by the appliance manufacturer may cause fire, electric shock, or injury.

• This appliance must not be immersed

• To disconnect remove the plug from the main outlet. Do not pull the plug out by the cord.

• Never remove parts from the appliance, such as the feet, screws, and so on.

• Never use the appliance near a bath, shower or swimming pool.

• Never place flammable objects or clothing on top of the appliance.

• Allow a 100cm safe area around the appliance on the top and sides and a 150cm safe area at the front.

• Never use the appliance in a room with explosive gas such as petrol, or while using any kinds of flammable glues, sprays, or solvents.

• Prevent overheating of the appliance by keeping the air inlets and outlets clean and free of anything that may cause blockage.
  Check all inlets and outlets from time to time for accumulated dust. DO NOT COVER.

• Do not place any part of your body near the air inlet, outlet, or fins, to avoid personal injury, electric shock, or fire.

• If overheating should occur, the built-in overheating safety device will shut the appliance off.

• Caution: Some parts of this product can become very hot and cause burns. Particular attention must be given when children or vulnerable people are present.

• Do not insert any foreign objects into the grill.

• Keep all grills clear of any draped fabric or curtains.

• The appliance must not be located immediately below a mains socket. Do not use the appliance with a programmer, timer, or any other device that switches the appliance on automatically. A fire risk exists if the appliance is covered or positioned incorrectly.

• Do not operate this appliance for anything other than its intended use.

• This appliance is not intended for commercial use

• This product is intended for household use only. Do not use outdoors.

• This product is only intended for heating.

• Warning : It is hazardous for anyone other than a competent person to carry out any service or repair operation which involves the removal of a cover that gives protection against exposure to electrical parts.

• Warning: Children should not use this appliance. Close supervision is necessary when any appliances are used near children.

• Warning: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Children should be supervised to make sure that they do not play with or use the appliance.

• Warning: In order to avoid overheating, do not cover the heater

Electrical Safety

THIS APPLIANCE MUST BE PLUGGED INTO AN EARTHED SOCKET

• Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. This product is designed to operate on 220 – 240V AC; 50Hz. Connection to any other power source may damage the unit.
• This product may be fitted with a non-rewireable plug. If it is necessary to change the fuse in the plug, the fuse cover must be refitted. If the fuse cover becomes lost or damaged, the plug must not be used until a suitable replacement is obtained.
• If the plug has to be changed because it is not suitable for your socket or becomes damaged in any way, it should be cut off and an appropriate plug fitted. This should be carried out by a qualified electrician. The plug removed must be disposed of safely, as insertion into a 13 Amp socket is likely to cause an electrical hazard.

Positioning

• The heater can be positioned in the upright position (the Control panel is at the top):
• The distance between the heater’s bottom and the ground should be more than 30cm.
• The distance between the side of the heater and the wall or any other object should be more than 50cm.
• Heats up to 10 square meters (107 square feet) room.

FEATURE DIAGRAM

1. Control panel & display
2. Buttons
3. Air outlet| 4. Power indicator light
5. ON/OFF switch
---|---

For Customer Services please call 0345 209 7461 Or visit us at mda.russellhobbs.com

CONTROL PANEL

| On/Standby
---|---
Speed| Fan mode selection (low/high)
Temp +| Increase the temperature setting
Temp –| Decrease the temperature setting
Timer| Timer setting function (0 – 12 hours)

USING YOUR PLUG HEATER

Usage
Heats up to 10 square meters (107 square foot) room

1. Plug the heater into a suitable power outlet, ensuring all the positioning instructions are followed.
   Note: The heater must be positioned uprightly (the Control panel is at the top). The distance between the heater’s bottom and the ground should be more than 30cm, the distance between the side of the heater and the wall or any other object should be more than 50cm.

2. Press the ‘ON/OFF’ switch on side of the unit to the “On” position.
   The heater will turn on.

3. Press the ‘ ‘ button, the heater starts running

4. Press the ‘Temp. +’ button to increase the temperature setting or press the ‘Temp. –’ button to decrease the temperature To adjust the speed of the fan to high or low press the ‘Temp. –’ and ‘Temp. +’ buttons simultaneously. The display will show LL for low mode and HH for high mode

5. To set the timer function (0 – 12 hours) press the ‘Timer’  button. The display will show 0, press the timer button until you have set the timer to the number of hours you want the heater to run for before it will power itself off. The hour options for the timer are from 0 to 12 hrs. (in 1 hr increment).

6. When finished, press the ‘ ‘ button and the heater will stop the heating process immediately. However, the fan will continue to operate for approximately 1 minute to allow for the interior components to cool. The fan will then turn off automatically. Turn the power switch at the side of the heater to the ‘OFF’ position and unplug the heater from the power outlet.

Note:

• The product will run continuously unless the timer has been set or you turn off the power.
• When powering off the heater, the heater will stop the heating process immediately. However, the fan will continue to operate for approximately 1 minute to allow for the interior components to cool. The fan will then turn off automatically.

Safety Protective Devices
The appliance is fitted with an overheat protection system

• Overheat protection – the power to the heating elements will automatically cut off if the temperature of the heating elements exceeds a certain limit. In the event of overheating, the heater will stop operating. Switch the appliance off and allow it to completely cool.

Note: Overheating can be caused by obstruction to the air intake on the back of the machine or the grill on the front. If this occurs please disconnect the machine and allow it to cool for 30 minutes. Remove any obstruction and turn the machine back on.

CLEANING AND CARE

WARNING: Electrical Shock Hazard.
Before you clean the appliance, disconnect the mains plug from the wall socket.

• Allow the appliance to cool down completely before cleaning.
• Do not immerse the cord, plug, or appliance in any liquid or allow moisture to come into contact with electrical parts.
• Clean the outer surface using a moist cloth and wipe over with a dry, soft cloth.
• Do not use harsh detergents, abrasives, or spray-on cleaners.
• Don’t allow water to seep into the openings or come into contact with electrical connections.
• Allow sufficient drying time before operating again.
• Clean the air inlets and outlets regularly with a vacuum cleaner using the brush attachment (with regular use, at least twice a year).
• When the appliance is not in use. We recommend that the heater is re-packed in its original packaging and stored in a cool, dry place.

PROBLEM-SOLVING

My appliance does not work when I turn it on:

1. Check that your appliance is plugged in and the power is turned on at the mains socket.

2. Try another main socket.

3. Check the appliance is in an upright position.

4. Check that the thermostat setting has not been set too low.

5. Check if the Overheat protection has operated by leaving the appliance plugged in and giving it time to cool down.
   The heater should start to resume operating normally.

6. If the appliance still doesn’t work, do not try to repair it yourself.

If your appliance power is automatically cut off, follow the step below:

1. Unplug your appliance from the main socket and allow it to completely cool down.
2. Inspect your appliance. Clean the air inlet and air outlet with a vacuum cleaner if necessary. If there are any signs of physical damage (e.g. melting, or burning of the case), do not attempt to use the appliance. Please leave all maintenance work to qualified personnel.
3. Plugin the appliance and switch it on again. If it cuts off again, move the appliance to a better-ventilated location.

GUARANTEE AND CUSTOMER SERVICES

At Russell Hobbs, we take all our customer feedback seriously.
Feel free to contact our Customer Service Team, on 0345 209 7461, who will be more than happy to assist you.
This product is guaranteed for 12 months from the date of the original purchase. If any defect arises due to faulty materials or workmanship, the faulty product must be returned to the place of purchase.
Refund or replacement is at the discretion of the retailer.
The following conditions apply:

• The product must be returned to the retailer with the original proof of purchase.

• The product must be installed and used in accordance with the instructions contained in this instruction guide and any other
  instructions for use that are supplied.

• It must be used for domestic purposes only and for its intended use.

• This warranty does not cover wear and tear, damage, misuse, or consumable parts.

This does not affect your statutory rights.
For Customer Services please call 0345 209 7461 Or visit us at mda.russellhobbs.com

CONNECTION TO THE MAINS SUPPLY

This appliance is designed to operate from the main supply of 220-240V~50Hz/60Hz.
Check that the voltage marked on the product corresponds with your supply voltage.
How to change the fuse

1. Slot the end of a screwdriver into the recess in the fuse holder of the plug.
2. Pull the fuse holder upwards until free of the plug and slide the fuse out.
3. Replace the fuse and replace the fuse holder, pushing down until locked into place.

Important: Only ever use a 13 amp fuse.

SPECIFICATION

only
Nominal heat output| nom| 0.5| kW| | manual heat charge control, with integrated thermostat| NA
Minimum heat output indicative)| °min| 0| kW| | manual heat charge control with room and/or outdoor temperature feedback| NA
Maximum continuous heat output| . max,c| 0.5| kW| | electronic heat charge control with| NA
room and/or outdoor temperature feedback
| | | | | fan assisted heat output| NA
Auxiliary electricity consumption| | Type of heat output/room temperature control
At nominal heat output| `’max| 0| kW| | single-stage heat output and no room temperature control| No
At minimum heat output| °min| 0| kW| | Two or more manual stages, no room temperature control| No
In standby mode| CIO| 0.00038| kW| | with mechanic thermostat room temperature control| Yes
| | | | | with electronic room temperature control| No
| | | | | electronic room temperature control plus day timer| Yes
| | | | | electronic room temperature control plus week timer| No
| | | | | Other control options (multiple selections possible)
| | | | | room temperature control, with presence detection| No
| | | | | room temperature control, with open window detection| No
| | | | | with distance control option| No
| | | | | with adaptive start control| No
| | | | | with working time limitation| Yes
| | | | | with black bulb sensor| No
Contact details| G25 LIMITED, WIGAN, WN2 4AY
G2S (NI) Ltd, Belfast, BT5 5AD

Russell Hobbs is a registered trademark used under license from Spectrum Brands (UK) Ltd. Made under license by G2S Limited, Wigan, WN2 4AY/G2S (NI) Ltd, Belfast, BT5 5AD.
Russell Hobbs Support: call 0345 209 7461 or visit: mda.russellhobbs.com

The ‘wheelie bin’ symbol is known as the ‘Crossed-out wheelie bin Symbol’. When this symbol is marked on a product/battery, it means that the product/batteries should not be disposed of with your general household waste. Only discard electrical/electronic/battery items in separate collection schemes, which cater for the recovery and recycling of materials contained within. Your co-operation is vital to ensure the success of these schemes and for the protection of the environment. For your nearest disposal facility, visit www.recycle-more.co.uk or ask in-store for details.
SEDEX – Connecting businesses and their global suppliers to share ethical data and enabling improvement in ethical performance. Visit www.sedex.org.uk for further information.
We reserve the right, due to possible changes to the design, to alter the
instruction manual without prior notice.
Revision 2.2

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>