SK Pang RSP-PICAN-M-CASE Metal Case for Pican-M Instruction Manual
- June 6, 2024
- SK Pang
Table of Contents
PiCAN-M Case Assembly Instructions
March 2021
| Product name | Metal case for PiCAN-M and Raspberry Pi 4 |
|---|---|
| Model number | RSP-PICAN-M-CASE |
| Manufacturer | SK Pang Electronics Ltd |
Introduction
This document is the instructions for assembling the PiCAN-M board with the n Raspberry Pi 4. A small Philips screwdriver is required.
Methods
First, check all parts are present. Separate the 8x countersunk and 8x pan head screws. There might be two different lengths of the pan head screws supplied.
Remove the M12 nut and 5way connector from the PiCAN-M board.
Place the Raspberry Pi 4 on the lower half of the case and fasten with 4 x pan
head screws. Use short pan head screws if two lengths are in the bag.
Place 4x brass spacer
inside the top half of the case. Fasten with 4x countersunk screws.
| 
---|---
Turn the PiCAN-M board upside down and place it on top of the brass spacers.
You may need to push the sidewall out slightly in order to lower the board in
place. Fasten with 4x pan head screw. Use a long version if two different
lengths are supplied.
Place top half and lower next to
each other ready for final assembly.
Slide the top half to the lower half.
Make sure it is aligned with no gaps.
Not aligned correctly.
Fasten with 4x
countersunk screws. Two on each side. Fasten the M12 nut and push the 5way
screw terminal in.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>