Time2 N40P Outdoor Siren to the Noah Hub User Guide
- June 6, 2024
- Time2
Table of Contents
Outdoor Siren User Guide
Connect the outdoor siren to the Noah hub as an additional siren. The siren acts as a repeater so when Noah is armed, it will make a loud beeping sound to alert you and the built-in strobe LED will flash continuously acting as a deterrent. If the alarm is triggered, the siren will sound for 5 minutes and the strobe LED will flash quickly.
**Pairing the outdoor siren to the Noah Hub
**
Please ensure the outdoor siren has been paired with the Noah Hub prior to mounting the siren outdoors
You will need the following to pair the siren to the Noah hub.
– Outdoor siren
– Noah hub
– Remote Control (provided with the Noah hub)
-
Plug the siren into power using the UK power adapter provided
-
Open the back cover of the siren and press the blue power button to switch the siren on. The siren will make a beeping sound when it is on.
-
Then press the pairing “learn” button. The siren will enter pairing mode – the strobe LED will come on and the siren will make a
beeping sound -
Arm the Noah hub
-
Then press the pairing “learn” button on the back of the siren again
-
Lastly, test the outdoor siren by using the remote control. The outdoor siren will also make a beeping noise. Please note: As the siren acts as a repeater to the Noah Hub, it does not appear in the Accessories menu.
**Where to install the outdoor siren
**
Fit the siren to the outside of your home where it is clearly visible and at a height that is not easily accessible by an intruder. Mount the siren at a distance of more than 1 metre away from any external or internal metalwork such as drainpipes, gutters, radiators etc.
**Installing the outdoor siren
**
Before the outdoor siren is mounted, ensure the siren is in Installation Mode, this reduces the risk of the siren being triggered whilst being installed.
To activate installation mode, simply press the disarm button on the remote
control 3 times. The strobe LED will flash continuously when
the siren is in installation mode.
1. Use a piece of paper to create a screw template for the siren and mark the
correct screw positions onto the wall|
---|---
2. Using the screw template, drill the screws into the wall| 
3. Connect the siren to the main power supply using the charging
adapter provided|
4. Finish mounting by fixing the siren onto the screws and positioning it
into place.| 
Once the siren has been installed successfully. Press the disarm button on the remote control again to deactivate installation mode.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>