hama 00186437 Air Purifier Instruction Manual

: June 6, 2024
: Hama

Table of Contents

Explanation of warning symbols and notes
Safety instructions
Package contents
Connection to the mains
Installing the app
Integrating devices into the Hama Smart Home (Solution) app
Control via voice assistants
Technical data
Care and maintenance
Recycling information
RF exposure information
Declaration of conformity
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

**hama 00186437 Air Purifier Instruction Manual

**

Thank you for choosing a Hama product. Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference. If you sell the device, please pass these operating instructions on to the new owner.

Explanation of warning symbols and notes

Risk of electric shock
This symbol indicates a risk of electric shock from touching product parts carrying hazardous voltage.
Warning
This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or important notes.

Safety instructions

The product is intended for private, non-commercial use only.
Use the product only for the intended purpose.
Protect the product from dirt, moisture and overheating and use it in dry rooms only.
Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
The product is intended only for use inside buildings.
Only use the article under moderate climatic conditions.
As with all electrical products, this device should be kept out of the reach of children.
Do not operate the product outside the power limits specified in the technical data.
Do not use the product in areas in which electronic products are not permitted.
Do not use the product in a damp environment and avoid splashing water.
Do not drop the product and do not expose it to any major shocks.
Do not modify the product in any way. Doing so voids the warranty.
Keep the packaging material out of the reach of children due to the risk of suffocation.
Dispose of packaging material immediately in accordance with the locally applicable regulations.
Route all cables so that there is no risk of tripping.
Do not bend or crush the cable.
Always pull directly on the plug when disconnecting the cable, never on the cable itself.
This device is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the device by a person responsible for their safety.

Risk of electric shock

Do not open the device or continue to operate it if it becomes damaged.
Do not use the product if the AC adapter, the adapter cable or the mains cable are damaged.
Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.

Package contents

1 xair purifier
1 xcombi filter
1 xoperating instructions

Connection to the mains

Warning

Only operate the product from an approved socket that is connected to the public power supply. The socket must be installed close to the product and must be easily accessible.
Disconnect the product from the power supply using the On/Off switch – if this is not available, unplug the power cord from the socket.
If using a multi-socket power strip, make sure that the total power consumption of all connected devices does not exceed the power strip‘s maximum throughput rating.
If you will not be using the product for a prolonged period, disconnect it from mains power.
Place the air purifier on a stable, flat surface. Connect the air purifier to a properly installed socket.

Installing the app

Download the „Hama Smart Home (Solution)“ app using the QR code and install it.

Installation Instruction
https://de.hama.com/
smarthome#smart-solution

Integrating devices into the Hama Smart Home (Solution) app

Make sure your mobile phone is connected to a 2.4 GHz WiFi network. To connect the air purifier to the app, first connect it to a properly installed socket. If the air purifier is now in standby status, the WiFi symbol should flash quickly on the display. If the symbol does not appear or flashes slowly, press and hold the button for 5 seconds. Now the WiFi symbol flashes quickly.
Integrating devices

Open the app and select „My home“ at the bottom left-hand edge of the screen.
Then tap the „+“ at the top right-hand edge of the screen and select the category „Air purifier“.
Now select your WiFi network and enter your password.
Check the box in the „Next step“ and click NEXT.
If the connection is successful, the app confirms that the air purifier has been incorporated. You can now assign the air purifier a different name if you wish.
Click on „Done“ to complete the process.

If the previously described method for integrating the air purifier does not work, there is the option of connecting the device via access point (AP) mode.

In the first step, the WiFi indicator on the air purifier display must flash slowly. If this is not the case, repeatedly for about 5 seconds until it flashes slowly.
Now proceed in the same way as described before. Before you tick „Next step“, select AP mode in the top right-hand corner.
The following screen appears:
Now tick the next step, click Next and select „Connect now“ in the next screen. In the WLAN network overview, select the network with the name „SmartLife_XXXX“.
You can ignore any error message that you are currently not connected to the Internet and then return to the Hama Smart Home (Solution). Your air purifier is now connected.
After a successful connection, you will see that the WiFi symbol on the display stops flashing. It may disappear for a second and then light up green permanently.
To operate or configure the device, select 186437 (air purifier) under „My Home“. Tap on „Switch“ at the bottom left. The air purifier is now switched on as shown in ****Figure 1.
• Press „Wind Speed“. You can select between Auto, Low, Medium and High. Your selection is displayed accordingly at the top (Figure 2).
Under „Settings“, you can also set the light mode to Gentle (light dimmed), Standard or Off (Figure 3).
Tap „Settings“ at the bottom right. The timer can be set between 2, 4 and 8 hours. To cancel the timer, press „Settings“ again and then press „Cancel“ (Figure 4).

Control via voice assistants

The following voice commands are supported:
Switch on/off
„Alexa / OK Google, switch the air purifier on.“
„Alexa / OK Google, switch the air purifier off.“
„Alexa / OK Google, switch the air purifier to low, medium, high, auto.

Technical data

Device dimensions	244 x 244 x 544 cm
Power supply	24V
Power consumption	45 W
CADR value	250 m³/h
Suitable for rooms up to	21 m² (Ansi/AHAM AC -1 2015) –

65 m² (NRCC – 54013 – 2011)
Filter type| Pre/coarse filter; Hepa 13 filter; Activated charcoal filter
Weight| 4.08kg

Care and maintenance

Note
Disconnect the device from the mains before cleaning and during prolonged periods of non-use.

Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents.
Ensure that no water is able to enter the product.
See also the „Replace Filter“ section for detailed cleaning instructions.

Inserting/changing the filter

Warning

Make sure that the product is disconnected from the mains.
Since the filter contains all the collected pollutants, it should only be changed outdoors and with appropriate care against contact contamination (gloves/respiratory protection).
The filter must be inserted before the first start-up.
To do this, proceed as follows:
Lay the air purifier on its side.
Turn the base plate a quarter turn anticlockwise. The base plate can be removed. (Fig. 1)
Remove the used filter, if any, and dispose of it in your household waste. (Fig. 2)
Remove the new filter from the protective packaging (Fig. 3) and insert it into the device. (Fig. 4)
Now reinsert the base plate into the latching lugs. Turn the base plate clockwise to tighten. (Fig. 5)
After a filter change, go to the Hama Smart Home (Solution) app to reset the filter. Click the „Reset filter“ field.

Setup Instruction

Recycling information

Note on environmental protection:
Following the implementation of European Directive 2012/19/EU and 2006/66/EU into the national legal systems, the following applies: Electrical and electronic devices as well as batteries must not be disposed of with household waste. Consumers are obliged by law to return electrical and electronic devices as well as batteries to the designated public collection points or to the point of sale at the end of their service lives. Detailed information on this topic is defined in the national laws of the respective country. This presence of the above symbol on the product, operating instructions or package indicates that the product is subject to these regulations. By recycling, reusing the materials or other forms of utilising old devices/batteries, you are making an important contribution to protecting our environment.

RF exposure information

This device complies with the EU requirements for limiting the exposure of the general public to electromagnetic fields by means of health protection.
The device complies with RF specifications provided it is used 20 cm away from the body.

Declaration of conformity

Hama GmbH & Co KG hereby declares that the radio equipment type [00186437] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity can be found on the following website: www.hama.com-> 00186437 ->Downloads.