hama 200133 USB Multiport Instruction Manual

00 200133
USB Multiport
Operating Instructions

Dual Ports
Connected| 1080P/60Hz| 1080P/60Hz|
108OP/60Hz| | 1080P/60Hz
| 1080P/60Hz| 1080P/60Hz
Triple Ports Connected| 1080P/60Hz| 1080P/6011z| 1080P/60Hz

Package Contents

• USB-C Multiport
• These operating instructions

Safety Notes

• Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
• Do not open the device or continue to operate it if it becomes damaged.
• Do not operate the product outside the power limits given in the specifications.
• Do not modify the product in any way. Doing so voids the warranty.
• Keep this product, as all electrical products, out of the reach of children! Use the product for its intended purpose only.
• Protect the product from dirt, moistureand overheating, and only use it in an adry environment.
• The product is intended for indoor use only.
• Do not use the product in the immediate vicinity of heaters or other heat sources or in direct sunlight.
• Do not use the product in moist environments and avoid splashes.
• Do not use the product in areas where the use of electronic devices is not permitted.
• Do not drop the product and do not expose it to any major shocks.
• Dispose of packaging material immediately according to locally applicable regulations.

Warning

• Find out the maximum output current capacity of the USB port on your device. To do this, consult the operating instructions or ask the manufacturer.
• Common values are500 mA for USB-A2.0, 900 mA for USB-A3.0, and up to 3000 mA for USB-C.
• Ensure that the cumulative current draw of all USB devices connected to the hub/multiport adaptor does not exceed this value.

Note

• To be able to use the charging function, the device must support Power Delivery (PD) or Thunderbolt-3/4.
• To be able to use the VGA or HDMI™ function, the device must support DisplayPort Alternate Mode or Thunderbolt-3/4.
• VGA &HDMI™2, or HDMI™1 and HDMI™2: MST(Multi-Stream Transport) support for simultaneous use of two monitors displaying different contents.
• Passive VGA/HDMI™ cables (without chipset /signal converter) must be used for MST.
• The MST function is dependent on the graphics card, operating system and monitor used. For more information, consult the operating instructions or contact the manufacturer.
• The MacBook must have an Intel processor (CPU). The Apple M1chip does not support MST!

Startup and Operation

• Switch on your computer and boot the system.
• Connect the product to two free USB ports on your computer.
• You do not have to install drivers; the computer will automatically recognize the product.
• If necessary, follow the instructions for your operating system.
• In order to use your devices, plug them into the product one after the other.

Warranty Disclaimer

Hama GmbH &CoKGassumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failuretoobserve the operating instructions and/ or safety notes.

**** Technical Data

**Note**

• If the is interference or the product no longer responds, unplug the product, wait a few seconds and then plug it in again.

Hama GmbH &CoKG
86652 Monheim /Germany
Service &Support
 www.hama.com
+49 9091 502-0

All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied.
00118654/08.21

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>