Metra Replacement Auxiliary Light with Halo and Turn Signal Instructions
- June 6, 2024
- Metra
Table of Contents
Metra Replacement Auxiliary Light with Halo and Turn Signal
The headlight replacements come with a H4 connector. This connector contains, both high and low beam connections, and a common ground.
To use the DRL function, connect the DRL wire to a switched +12V source, such as an accessory or ignition circuit. The DRL halo will illuminate when this circuit is activated.
Single Headlight: Connect the Turn Signal wire to both the left and right
+12V turn signal light sources. You MUST diode isolate the connection to these
sources.
Dual Headlight: Connect the Turn Signal wire to the +12V source for the
turn signal light for that side of the bike.
460 Walker Street, Holly Hill, FL 32117
www.MetraOnline.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>